1. Product Overview
The DANCO VersiTech Cartridge 10773 is designed as a replacement component for leaky tub and shower faucets. Constructed from durable plastic, this cartridge ensures reliable performance and is compatible with hot and cold water applications. It is specifically engineered to fit Glacier Bay, AquaSource, and PurePro faucet models, offering a practical solution to extend the life of your existing faucet without requiring a full replacement.
2. Setup and Installation
Before beginning installation, ensure the main water supply to your home is turned off to prevent water damage. Gather necessary tools such as a screwdriver, adjustable wrench, and possibly a cartridge puller.
- Remove Faucet Handle: Carefully remove the screw securing the faucet handle. This screw is often located under a decorative cap. Once the screw is removed, pull the handle off.
- Remove Trim Plate: Unscrew and remove the decorative trim plate (escutcheon) to expose the cartridge housing.
- Extract Old Cartridge: Depending on your faucet model, you may need a cartridge puller tool to remove the old cartridge. Grip the stem of the old cartridge and pull it straight out. Note the orientation of the old cartridge for correct installation of the new one.
- Clean Housing: Inspect the inside of the faucet body for any debris or mineral buildup. Clean thoroughly to ensure a proper seal for the new cartridge.
- Install New Cartridge: Insert the new DANCO VersiTech Cartridge 10773 into the faucet body, ensuring it is correctly aligned. The hot and cold indicators (red and blue) on the cartridge should typically align with the corresponding markings on the faucet body or your desired hot/cold orientation.
- Reassemble Faucet: Reattach the trim plate and secure it with screws. Place the faucet handle back onto the stem and tighten its screw.
- Restore Water Supply: Slowly turn the main water supply back on. Check for any leaks around the faucet.
For additional guidance on identifying the correct replacement part or detailed installation videos, you may visit the Danco Leaky Faucet Guide.
3. Operation
The DANCO VersiTech Cartridge 10773 controls the flow and temperature of water in your tub and shower faucet. Once installed, the faucet handle will operate as designed by the original manufacturer, allowing you to adjust water temperature and volume. The cartridge is designed to handle both hot and cold water applications effectively.
4. Maintenance
To ensure the longevity and optimal performance of your DANCO VersiTech Cartridge, regular maintenance is recommended:
- Regular Cleaning: Periodically clean the faucet exterior and handle with a soft cloth and mild, non-abrasive cleaner. Avoid harsh chemicals that can damage the finish.
- Check for Leaks: Regularly inspect the faucet for any signs of dripping or leaks. Addressing minor leaks promptly can prevent further damage and water waste.
- Water Quality: In areas with hard water, mineral deposits can accumulate over time. If water flow becomes restricted or temperature control is affected, the cartridge may need to be inspected or replaced.
5. Troubleshooting
If you encounter issues after installing the DANCO VersiTech Cartridge, consider the following troubleshooting steps:
- Leaking Faucet: If the faucet continues to leak after cartridge replacement, ensure the cartridge is fully seated and properly aligned. Check for any debris in the cartridge housing that might prevent a tight seal. Verify that the O-rings on the cartridge are intact and correctly positioned.
- No Hot or Cold Water: If only hot or cold water is flowing, or if temperature control is erratic, check the orientation of the cartridge. The hot and cold indicators (red and blue) must be correctly aligned with the faucet's internal channels.
- Low Water Pressure: Reduced water pressure might indicate a blockage. Remove the cartridge and inspect it and the faucet body for any mineral buildup or debris.
- Stiff Handle Operation: If the handle is difficult to turn, ensure all components are properly lubricated (using plumber's grease suitable for potable water) and that no parts are overtightened.
6. Specifications
| Feature | Detail |
|---|---|
| Brand | Danco |
| Model Number | 10773 |
| Material | Plastic |
| Compatibility | Glacier Bay, AquaSource, PurePro faucets |
| Special Features | Leak Elimination, Low Lead Compliance |
| Item Weight | 6.4 ounces |
| Product Dimensions | 5.25 x 1.5 x 1.5 inches |
| Water Application | Hot and Cold |
7. Warranty and Support
The DANCO VersiTech Cartridge 10773 comes with a Limited 1 Year Warranty. For warranty claims or technical support, please refer to the contact information provided by Danco or your product retailer. Keep your purchase receipt as proof of purchase.
For further assistance or to find other Danco products, visit the official Danco Store on Amazon.
