Introduction
This manual provides comprehensive instructions for the setup, operation, and maintenance of your Westclox 72028 Travel Alarm Clock. Please read these instructions carefully to ensure proper use and to maximize the functionality of your device.
Product Features
- 5-inch LCD display with bluelight illumination.
- Digital time and date display.
- Snooze alarm function.
- Light on demand for nighttime viewing.
- Compact and foldable design for travel.
Setup
Battery Installation
The Westclox 72028 Travel Alarm Clock requires one (1) AA battery (not included) for operation. Follow these steps to install the battery:
- Locate the battery compartment cover on the back of the clock.
- Carefully slide or unclip the cover to open the compartment.
- Insert one new AA battery, ensuring the positive (+) and negative (-) terminals align with the indicators inside the compartment.
- Replace the battery compartment cover securely.
Note: Ensure correct battery polarity to prevent damage to the clock. Remove batteries if the clock will not be used for an extended period.
Operating Instructions
This image displays the Westclox 72028 Travel Alarm Clock. The clock features a black casing with a silver trim. The digital LCD screen shows '4:13 AM', 'TH' for Thursday, and '1/2' for January 2. Below the screen are control buttons: 'MODE', 'SET', 'UP', 'DOWN', and an 'ALARM ON/OFF' button with a bell icon. A 'SNOOZE / LIGHT' button is located at the top. The clock is shown with its foldable stand extended.
Button Functions Overview
- SNOOZE / LIGHT: Activates the display backlight and snoozes the alarm.
- MODE (M): Cycles through display modes (Time, Alarm, Date).
- SET (S): Enters setting mode for the currently displayed mode.
- UP (▲): Increases values during setting.
- DOWN (▼): Decreases values during setting.
- ALARM ON/OFF (Bell Icon): Toggles the alarm function on or off.
Setting Time and Date
- Press the MODE button repeatedly until the current time is displayed.
- Press and hold the SET button until the hour digit begins to flash.
- Use the UP or DOWN buttons to adjust the hour. Pay attention to the AM/PM indicator.
- Press the SET button again to move to the minute digit. Use UP or DOWN to adjust.
- Continue pressing SET to cycle through setting the year, month, and date, adjusting each with the UP or DOWN buttons.
- Once all settings are complete, press MODE to exit the setting mode.
Setting the Alarm
- Press the MODE button until the alarm time is displayed (often indicated by a small bell icon or 'AL').
- Press and hold the SET button until the alarm hour digit begins to flash.
- Use the UP or DOWN buttons to adjust the alarm hour.
- Press the SET button again to move to the alarm minute digit. Use UP or DOWN to adjust.
- Press MODE to exit the alarm setting mode.
- To activate or deactivate the alarm, press the ALARM ON/OFF button (bell icon). A small bell icon on the display indicates the alarm is active.
Snooze and Light Function
- When the alarm sounds, press the SNOOZE / LIGHT button to temporarily silence the alarm. The alarm will sound again after a few minutes (typically 5-10 minutes).
- To activate the display backlight at any time, press the SNOOZE / LIGHT button. The light will illuminate for a few seconds.
Maintenance
- Cleaning: Wipe the clock with a soft, dry cloth. Do not use abrasive cleaners or solvents.
- Battery Replacement: Replace the AA battery annually or when the display dims or functions become erratic.
- Storage: If storing the clock for an extended period, remove the battery to prevent leakage.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Clock display is blank or dim. | Low or dead battery; incorrect battery installation. | Replace the AA battery with a new one, ensuring correct polarity. |
| Alarm does not sound or is too quiet. | Alarm is not activated; alarm volume is fixed and may be perceived as low. | Ensure the alarm icon is visible on the display. The alarm volume is preset and cannot be adjusted. Position the clock closer to your bed if needed. |
| Cannot set time or alarm. | Not in setting mode; incorrect button sequence. | Refer to the 'Setting Time and Date' or 'Setting the Alarm' sections and follow the steps precisely. Ensure you press and hold the SET button to enter setting mode. |
| Display shows incorrect day/date. | Date not set correctly. | Follow the 'Setting Time and Date' instructions to correct the date. |
Specifications
- Brand: Westclox
- Model: 72028
- Display Type: Digital LCD
- Color: Black
- Dimensions: Approximately 3"W x 3"H (folded)
- Power Source: 1 x AA Battery (not included)
- Special Features: Alarm, Foldable, Bluelight LCD
- Material: Plastic
- Item Weight: 3.2 ounces
Warranty and Support
For warranty information or technical support regarding your Westclox 72028 Travel Alarm Clock, please refer to the contact information provided with your purchase or visit the official Westclox website. Keep your purchase receipt as proof of purchase.
