Introduction
Thank you for choosing the Jaclo 8043-ACU Brass Showerarm. This manual provides detailed instructions for the proper installation, operation, and maintenance of your new showerarm. Please read this manual thoroughly before beginning installation to ensure safe and correct usage. Retain this manual for future reference.
Safety Information
- Always turn off the main water supply before attempting any plumbing installation or repair.
- Wear appropriate personal protective equipment, such as safety glasses and gloves, during installation.
- If you are unsure about any part of the installation process, consult a qualified plumber.
- Do not overtighten connections, as this can damage threads or components.
- Keep small parts away from children.
Package Contents
Verify that all components are present before beginning installation:
- Jaclo 8043-ACU Brass Showerarm (1 unit)
- (Note: Escutcheon plate and showerhead are typically sold separately and are not included with the showerarm.)
Figure 1: Jaclo 8043-ACU Brass Showerarm. This image displays the Jaclo 8043-ACU Brass Showerarm. It features a 60-degree angled design and an antique copper finish. Both ends of the showerarm are threaded for connection to a water supply and a showerhead.
Tools Required (Not Included)
- Adjustable wrench or pipe wrench
- Plumber's tape (thread seal tape)
- Soft cloth or rag
Installation Instructions
- Prepare the Area: Turn off the main water supply to your home. Open a faucet to relieve any remaining water pressure in the pipes.
- Remove Existing Showerarm (if applicable): If replacing an old showerarm, carefully unscrew it from the wall fitting using an adjustable wrench. Clean any old sealant or debris from the wall opening and threads.
- Apply Plumber's Tape: Wrap plumber's tape clockwise around the threaded end of the new Jaclo showerarm that will connect to the wall fitting. Apply 3-4 layers of tape to ensure a watertight seal.
- Install Showerarm: Carefully thread the showerarm into the wall fitting by hand. Ensure it is straight and the 60-degree bend is oriented correctly for your showerhead. Once hand-tight, use an adjustable wrench to tighten it an additional 1/2 to 3/4 turn. Avoid overtightening.
- Install Escutcheon Plate (if applicable): Slide the escutcheon plate (if using one, sold separately) over the showerarm until it sits flush against the wall, covering the opening.
- Connect Showerhead: Apply plumber's tape to the exposed threaded end of the showerarm. Thread your showerhead onto the showerarm by hand, then tighten with an adjustable wrench an additional 1/4 to 1/2 turn. Do not overtighten.
- Test for Leaks: Turn the main water supply back on slowly. Check all connections for leaks. If leaks are present, tighten the connections slightly until the leak stops. Do not overtighten.
Operation
The Jaclo 8043-ACU Brass Showerarm functions as a conduit for water from your wall fitting to your showerhead. Once installed, operate your shower as usual. The 60-degree angle is designed to position your showerhead optimally for a comfortable showering experience.
Maintenance and Care
- Cleaning: To maintain the antique copper finish, clean regularly with a soft, damp cloth. Avoid abrasive cleaners, harsh chemicals, or scouring pads, as these can damage the finish.
- Spot Cleaning: For stubborn spots, use a mild soap solution and a soft cloth, then rinse thoroughly with water and dry immediately.
- Avoid Wax-Based Cleaners: Do not use wax-based cleaners, as they can build up and dull the finish.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Water leaks at wall connection. | Insufficient plumber's tape or loose connection. | Turn off water supply. Remove showerarm, reapply plumber's tape (3-4 layers), and re-tighten. Do not overtighten. |
| Water leaks at showerhead connection. | Insufficient plumber's tape or loose connection. | Turn off water supply. Remove showerhead, reapply plumber's tape, and re-tighten. Do not overtighten. |
| Showerarm feels loose after installation. | Not tightened sufficiently into wall fitting. | Turn off water supply. Gently tighten the showerarm into the wall fitting using an adjustable wrench until secure. |
Specifications
- Model: 8043-ACU
- Brand: Jaclo
- Material: Brass
- Finish: Antique Copper
- Angle: 60 Degrees
- Length: 8 inches
- Item Weight: Approximately 1.48 pounds (0.67 kg)
- Product Dimensions: Approximately 3 x 6 x 3 inches (7.6 x 15.2 x 7.6 cm)
- UPC: 020111167928
- Manufacturer: Standard Plumbing Supply
Warranty and Support
Jaclo products are manufactured to high-quality standards and are backed by a manufacturer's warranty. For specific warranty details, product support, or to inquire about replacement parts, please contact Jaclo customer service directly or visit their official website. Please have your model number (8043-ACU) and proof of purchase available when contacting support.
For further assistance, please refer to the official Jaclo website or contact your retailer.