Paulmann 400.30 AGL Halogen Lamp 42W B22d Clear - Instruction Manual

1. Introduction

Thank you for choosing the Paulmann 400.30 AGL Halogen Lamp. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your new halogen bulb. Please read these instructions carefully before use and retain them for future reference.

2. Safety Instructions

• Electrical Safety: Always disconnect power before installing, removing, or cleaning the lamp. Ensure your hands are dry when handling electrical components.
• Correct Wattage: Do not exceed the maximum wattage specified for your light fixture. This lamp is 42W.
• Lamp Base: Ensure the lamp base (B22d) matches your fixture's socket type.
• Heat: Halogen lamps generate significant heat. Avoid touching the lamp directly when it is on or immediately after it has been switched off. Allow sufficient cooling time.
• Disposal: Dispose of used lamps according to local regulations.
• Indoor Use: This lamp is designed for indoor use unless otherwise specified by the fixture.

3. Product Overview

The Paulmann 400.30 is a clear AGL (General Lighting Service) halogen lamp designed for standard B22d bayonet cap fittings. It provides 42 watts of illumination and is compatible with R, L, C universal dimmers.

Figure 1: Paulmann 400.30 AGL Halogen Lamp with B22d base. This image shows the clear glass bulb and the bayonet cap base with two pins for secure fitting into compatible light fixtures.

Figure 2: Energy efficiency label for Paulmann 400.30, indicating an energy rating of D and consumption of 42 kWh/1000h.

4. Setup and Installation

1. Power Off: Ensure the power supply to the light fixture is completely switched off at the main circuit breaker before beginning installation.
2. Cool Down: If replacing an existing bulb, allow the old bulb to cool down completely before touching it.
3. Insert Bulb: Align the two pins on the B22d base of the Paulmann 400.30 lamp with the slots in the light fixture's socket. Push the bulb gently into the socket and twist clockwise until it locks securely into place.
4. Restore Power: Once the bulb is securely installed, restore power to the light fixture.

5. Operating Instructions

To operate the Paulmann 400.30 halogen lamp, simply switch on the power to the light fixture. This lamp is designed to be compatible with R, L, C universal dimmers, allowing you to adjust the light intensity if your fixture and dimmer switch support this functionality. Refer to your dimmer's instructions for specific operation details.

6. Maintenance

• Cleaning: Ensure the lamp is switched off and completely cool before cleaning. Gently wipe the glass bulb with a soft, dry, lint-free cloth. Do not use liquid cleaners or abrasive materials.
• Replacement: When the lamp reaches the end of its lifespan, follow the installation steps in reverse to remove the old bulb, ensuring power is off and the bulb is cool. Install a new Paulmann 400.30 or an equivalent B22d 42W halogen lamp.

7. Troubleshooting

• Lamp Not Lighting Up:
  • Check if the power supply to the fixture is on.
  • Ensure the lamp is correctly seated and twisted securely in the socket.
  • Verify that the lamp is not faulty by testing it in another compatible fixture or trying a new lamp in the current fixture.
  • Check the circuit breaker for the fixture.
• Lamp Flickering:
  • Ensure the lamp is securely installed.
  • If using a dimmer, ensure it is compatible with halogen lamps and functioning correctly.
  • Check for loose wiring in the fixture or switch (consult a qualified electrician if unsure).

8. Specifications

9. Warranty and Support

Paulmann products are manufactured to high-quality standards. For specific warranty information, please refer to the documentation provided with your purchase or visit the official Paulmann website. For technical support or inquiries, please contact Paulmann customer service through their official channels.

Website: www.paulmann.com