Dentemp Maximum Strength Temporary Dental Repair Kit

Product Overview

This manual provides instructions for using Dentemp Maximum Strength Temporary Dental Repair Kit, designed for temporary repair of loose caps, crowns, and lost fillings. It offers quick relief from discomfort until professional dental care can be obtained. The formula is ready-to-use, requires no mixing, and sets quickly, allowing normal eating and drinking within two hours of application. Each kit includes an applicator for precise application.

Image: Dentemp Maximum Strength Temporary Dental Repair Kit in its retail packaging.

Safety Information

• For external use only.
• If irritation occurs, discontinue use.
• Keep out of reach of children.
• Caution: Do not use if allergic to Eugenol or other listed ingredients.
• This product should not be used if throbbing pain or swelling in the affected area exists. Consult your dentist immediately.
• This product is sold as a temporary remedy. See your dentist as soon as possible for permanent work to be performed.
• Failure to do so may cause infection and/or serious injury.
• Store at room temperature with container closed to keep material soft. Lot code on container.
• Dental Repair should not be used on implants or posts without dentist's advice.

Ingredients

Calcium Sulphate, Barium Sulphate, Dimethoxyethylmethacrylate Polymer, Potassium Sulfate.

How to Use

Follow these instructions carefully for effective temporary dental repair. Wash hands thoroughly before beginning.

For Lost Fillings:

1. Wash hands and rinse the tooth cavity with warm water. Do not dry.
2. Use the provided applicator to remove a small amount of material from the vial.
3. With wet fingers, roll the Dentemp material into a ball.
4. Press the material firmly into the cavity.
5. Bite down several times to ensure a proper bite. Do not lift your finger straight up as this might loosen the material in the cavity.
6. Wait 15 minutes for the material to initially set. Remove any excess material with a damp cotton swab.
7. Allow at least two (2) hours to set before eating.

Image: Illustration showing the application of Dentemp to replace a lost filling.

For Loose Caps or Crowns:

1. Wash hands.
2. Prepare the crown by carefully removing as much old cement as possible from inside the crown. Rinse well.
3. Clean and rinse the tooth area with water and leave moist.
4. Fit the crown back on the tooth before applying new material. Make sure it fits properly. If you cannot do this, DO NOT PROCEED. See your dentist.
5. Use the applicator to remove a small amount of material from the vial.
6. Place a very small amount of material along the inside edge of the open end of the crown.
7. Place the crown on the wet tooth and press firmly.
8. Bite down several times to ensure a proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal.
9. Remove any excess material. Rinse your mouth well with water.
10. Allow at least two (2) hours to set before eating.

Image: Illustration showing the re-cementing of a loose crown using Dentemp.

Maintenance

Dentemp is a temporary repair solution. It is crucial to visit a dentist as soon as possible for a permanent repair. While Dentemp is designed to be durable for temporary use, avoid excessive chewing on the repaired tooth and maintain good oral hygiene to prolong its effectiveness until professional dental care is received.

Troubleshooting

• Material too soft/crumbly: Ensure the container is tightly closed and stored at room temperature to prevent the material from drying out or becoming too hard. If the material is too soft, it may be due to moisture; try to work with drier fingers. If too crumbly, ensure fingers are wet enough to form a ball.
• Repair not holding: Ensure the tooth cavity or crown is clean and moist before application. Press firmly and bite down several times to ensure proper adhesion. Avoid lifting your finger straight up after pressing the material into a cavity. Allow the full two hours for setting before eating.
• Discomfort persists: If pain or swelling continues or worsens, discontinue use and consult a dentist immediately. This product is for temporary relief only.
• Allergic reaction: Discontinue use immediately if you experience any signs of an allergic reaction to Eugenol or other ingredients.

Specifications

Warranty and Support

For questions or concerns regarding Dentemp products, please contact DOC Brands, Inc. customer support.

• Phone: 833-362-2763
• Email: consumeraffairs@doc-brands.com
• Website: www.dentemp.com

Please note that statements regarding dietary supplements have not been evaluated by the FDA and are not intended to diagnose, treat, cure, or prevent any disease or health condition. This product is intended for temporary use only.