Banshee BP-210N/BP-210

Banshee BP-210N/BP-210 Battery User Manual

For ICOM IC-A6, IC-A24, IC-V8, IC-V82, IC-U82 Two-Way Radios

Introduction

This manual provides essential instructions for the safe and effective use of your Banshee BP-210N/BP-210 rechargeable battery. Designed for compatibility with various ICOM two-way radio models, this battery delivers reliable power for your communication needs. Please read this manual thoroughly before initial use to ensure proper operation and to maximize battery life.

Banshee BP-210N/BP-210 Battery

Figure 1: Front view of the Banshee BP-210N/BP-210 battery, showing the label with part number, voltage (7.2V), capacity (1600mAh), and battery chemistry (NI-MH).

Safety Information

Observe the following safety precautions to prevent damage to the battery, radio, or personal injury:

Package Contents

Verify that your package contains the following item:

Setup and Installation

To install the Banshee BP-210N/BP-210 battery into your compatible ICOM radio:

  1. Ensure the radio is powered off before attempting battery installation or removal.
  2. Align the battery pack with the battery compartment on the back of your ICOM radio.
  3. Slide the battery pack into the compartment until it clicks securely into place. Ensure there is no gap between the battery and the radio body.
  4. To remove, locate the battery release latch (if present on your radio model), depress it, and slide the battery pack downwards or outwards.
Banshee BP-210N/BP-210 Battery with Belt Clip

Figure 2: Rear view of the Banshee BP-210N/BP-210 battery, showing the contacts and an attached belt clip, indicating readiness for radio integration.

Operating Instructions

Initial Charging

Before first use, fully charge the battery pack. This typically takes several hours. Refer to your ICOM radio's manual for specific charging instructions and recommended charger types. Use only chargers compatible with Ni-MH batteries.

Normal Charging

Connect the radio with the installed battery to its compatible charger. The charging indicator on your radio or charger will typically show the charging status. Disconnect the charger once the battery is fully charged to prevent overcharging, which can reduce battery life.

Usage

Once charged, the battery is ready for use with your ICOM radio. Monitor the radio's battery level indicator during operation. Recharge the battery when the indicator shows low power to avoid interruption of communication.

Maintenance

Banshee BP-210N/BP-210 Battery Angled View

Figure 3: Angled view of the Banshee BP-210N/BP-210 battery, highlighting the battery contacts and overall form factor.

Troubleshooting

ProblemPossible CauseSolution
Battery not charging
  • Incorrectly seated battery
  • Dirty battery/charger contacts
  • Faulty charger
  • Battery fully discharged (deep discharge)
  • Re-seat the battery firmly.
  • Clean contacts with a dry cloth.
  • Try a different compatible charger.
  • Attempt a slow, trickle charge if possible, or replace if severely damaged.
Short operating time after full charge
  • Battery not fully charged
  • Battery nearing end of life
  • Memory effect (for Ni-MH)
  • Ensure full charge cycle.
  • Consider replacing the battery.
  • Perform a full discharge/recharge cycle to mitigate memory effect.
Radio not powering on with battery
  • Battery not charged
  • Battery not properly installed
  • Battery faulty
  • Charge the battery.
  • Re-install the battery, ensuring it's secure.
  • Test with another known good battery if available.

Specifications

FeatureDetail
Model NumberBP-210N / BP-210 (QMB-BP213)
BrandBanshee
Battery Cell CompositionNickel-Metal Hydride (Ni-MH)
Voltage7.2V
Capacity1600mAh
ReusabilityRechargeable
Recommended UsesTwo-Way Radios (ICOM IC-A6, IC-A24, IC-V8, IC-V82, IC-U82)
ManufacturerTitan

Note: Specifications are subject to change without notice.

Warranty and Support

For warranty information or technical support regarding your Banshee BP-210N/BP-210 battery, please contact Banshee customer service. Refer to the product packaging or the official Banshee website for the most current contact details.

Online Support: Visit the Banshee Store on Amazon

Related Documents - BP-210N/BP-210

Preview ICOM IC-V88 and IC-U88 VHF/UHF Transceiver User Manual
Comprehensive instructions for the ICOM IC-V88 VHF and IC-U88 UHF transceivers, covering safety precautions, panel descriptions, function display, and battery charging.
Preview RADWAG X2 Synergy Moisture Analyzer User Manual
User manual for the RADWAG X2 Synergy Moisture Analyzer, detailing operation, safety, technical specifications, and maintenance for precise moisture content determination.
Preview Icom IC-F1000/F2000 Series VHF/UHF Transceiver Instructions
This document provides instructions for the Icom IC-F1000 and IC-F2000 series VHF/UHF transceivers, covering battery packs, chargers, antennas, accessories, panel descriptions, and basic operation including receiving and transmitting.
Preview Icom IC-T7H Dual Band FM Transceiver Instruction Manual
Comprehensive instruction manual for the Icom IC-T7H Dual Band FM Transceiver, covering operation, features, specifications, and troubleshooting.
Preview Icom IC-R30 Advanced Manual: Comprehensive Guide
Explore the advanced features of the Icom IC-R30 Communications Receiver with this detailed manual. Learn about power supply, microSD card usage, recording, memory operations, GPS, Bluetooth, firmware updates, and specifications.
Preview Icom IC-M90 VHF Marine Transceiver Instruction Manual
This manual provides detailed operating instructions for the Icom IC-M90 VHF Marine Transceiver, covering safety precautions, basic operations, scanning functions, and maintenance.