1. Product Overview
The Candy CMBI 970 LX is a wall-mounted cooker hood designed to efficiently remove smoke, steam, and cooking odors from your kitchen. Featuring a powerful extraction rate of 750 m³/h and LED lighting, this stainless steel hood combines functionality with a sleek design. It operates with a duct extraction system and is controlled via intuitive buttons.

Figure 1: Front view of the Candy CMBI 970 LX wall-mounted cooker hood, showcasing its stainless steel finish and control panel.
2. Safety Information
Please read all instructions carefully before installation and use. Keep this manual for future reference. Failure to follow these instructions may result in electric shock, fire, or injury.
- Electrical Safety: Ensure the power supply matches the voltage specified on the rating label. Always disconnect the appliance from the power supply before cleaning or maintenance.
- Installation: Installation must be carried out by a qualified person in accordance with all local regulations and standards. Ensure adequate ventilation in the room when the hood is used simultaneously with appliances burning gas or other fuels.
- Usage: This appliance is intended for domestic use only. Do not flambé under the cooker hood. Do not leave frying pans unattended during use as overheated oil can ignite.
- Cleaning: Regularly clean the appliance and its filters to prevent grease accumulation, which can pose a fire hazard.
- Children and Vulnerable Persons: This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
3. Installation Guide
The Candy CMBI 970 LX is a wall-mounted cooker hood designed for duct extraction. Proper installation is crucial for optimal performance and safety.
3.1 Pre-Installation Checks
- Verify that the wall structure is strong enough to support the hood's weight (approximately 22 kg).
- Ensure there is sufficient space for the hood, considering its dimensions: 90 cm (width) x 60 cm (depth) x 65 cm (height).
- Confirm the availability of a suitable electrical outlet and ducting system for air expulsion.
3.2 Mounting the Hood
- Mark the drilling points on the wall according to the provided template (if applicable, or measure carefully based on hood dimensions).
- Drill holes and insert wall plugs suitable for your wall type.
- Secure the mounting bracket to the wall.
- Carefully lift the hood and attach it to the mounting bracket. Ensure it is level and securely fastened.
- Connect the ducting to the exhaust outlet of the hood.
- Connect the hood to the electrical supply.

Figure 2: The Candy CMBI 970 LX cooker hood installed above a cooking range in a modern kitchen, demonstrating its wall-mounted design and integration.
Note: For detailed installation diagrams and specific measurements, please refer to the separate installation template usually included with the product packaging.
4. Operating Instructions
The Candy CMBI 970 LX cooker hood is operated using mechanical buttons located on the front panel.
4.1 Control Panel
The control panel typically includes buttons for:
- Power ON/OFF: To switch the hood on or off.
- Fan Speed Selection: Allows you to choose between 3 different fan speeds (low, medium, high) to adjust the extraction power according to your cooking needs. The maximum extraction power is 750 m³/h.
- Light ON/OFF: To control the integrated LED lighting, illuminating your cooking area.
4.2 Recommended Usage
- For light cooking (e.g., boiling water), use the lowest fan speed.
- For general cooking, use the medium fan speed.
- For heavy cooking, frying, or grilling, use the highest fan speed to ensure maximum air purification.
- Turn on the hood a few minutes before you start cooking and leave it on for a few minutes after you finish to ensure all odors and steam are cleared.
The typical noise level during operation is 64 dB, ensuring effective ventilation without excessive disturbance.
5. Maintenance and Cleaning
Regular maintenance ensures the longevity and optimal performance of your cooker hood. Always disconnect the appliance from the power supply before performing any cleaning or maintenance.
5.1 Grease Filters
The hood is equipped with 3 metallic grease filters designed to trap grease particles from cooking fumes. These filters should be cleaned regularly to prevent grease buildup and maintain extraction efficiency.
- Cleaning Frequency: Depending on usage, clean the grease filters every 2-4 weeks.
- Cleaning Method: The filters can be washed by hand in hot soapy water or in a dishwasher on a low-temperature cycle. Ensure they are completely dry before re-installing.
5.2 Carbon Filters (for Recirculation Mode)
If your hood is set up for recirculation (not ducting outside), it will use carbon filters to remove odors. The product features a carbon filter type.
- Replacement Frequency: Carbon filters cannot be washed and must be replaced every 3-6 months, depending on usage.
- Replacement: Refer to the specific instructions provided with the carbon filters for replacement procedures.
5.3 Exterior Cleaning
Clean the stainless steel exterior of the hood with a soft cloth dampened with mild detergent or a specialized stainless steel cleaner. Avoid abrasive cleaners or scouring pads that could scratch the surface.
5.4 Lighting
The hood uses LED lighting. For information on cleaning the bulbs, please refer to general guidelines on cleaning ampoules.
6. Troubleshooting
Before contacting customer support, please check the following common issues:
| Problem | Possible Cause | Solution |
|---|---|---|
| Hood does not turn on. | No power supply; Power cord disconnected; Blown fuse/tripped circuit breaker. | Check power connection; Ensure power cord is securely plugged in; Check household fuse box/circuit breaker. |
| Poor extraction performance. | Grease filters are clogged; Ducting is blocked or too long/narrow; Fan motor issue. | Clean or replace grease filters; Check ducting for obstructions; Contact qualified technician if motor issue is suspected. |
| Excessive noise during operation. | Loose components; Improper installation; Fan blades obstructed. | Check for loose screws or parts; Ensure hood is securely mounted; Inspect fan for obstructions (with power off). |
| Lights not working. | Bulb failure; Electrical connection issue. | Check if bulbs need replacement (LEDs typically have long life); Contact support if electrical issue. |
7. Technical Specifications
- Model: CMBI 970 LX
- Brand: Candy
- Type: Wall-mounted Cooker Hood
- Extraction Type: Duct (Conduit)
- Control Type: Mechanical Buttons
- Maximum Extraction Power: 750 m³/h
- Number of Fan Speeds: 3
- Noise Level: 64 dB (as per product description)
- Lighting: LED
- Number of Filters: 3 (Grease filters)
- Filter Type: Metallic Grease Filters, Carbon Filter (optional for recirculation)
- Material: Stainless Steel, Carbon, Metallic
- Color: Stainless Steel
- Dimensions (Depth x Width x Height): 60 x 90 x 65 cm
- Weight: 22 Kilograms
- Power: 230 Watts
- Voltage: 240 Volts
- Annual Energy Consumption: 95.7 kWh/year
- Energy Efficiency Class: D
- First Available Date: October 21, 2013
8. Warranty and Support
For warranty information, please refer to the documentation provided at the time of purchase or contact your retailer. Specific details regarding spare parts availability are not provided in this manual.
For technical assistance, troubleshooting beyond this guide, or to inquire about spare parts, please contact Candy customer support. You can typically find contact information on the official Candy website or through your product's purchase documentation.
Manufacturer: Candy
International Article Code: 08016361868441





