Introduction
This manual provides detailed instructions for the Fastrack Big Time Quartz Chronograph Watch, model NP3072SL02. Please read this manual carefully to ensure proper use and maintenance of your watch.
The Fastrack Big Time Chronograph is a quartz movement watch featuring a black dial, leather strap, and chronograph functions. It is designed for everyday wear and offers water resistance up to 50 meters.
Watch Components
Familiarize yourself with the main components of your watch:
- Crown: Used for setting time.
- Pushers (A and B): Used for operating the chronograph functions.
- Main Dial: Displays hours, minutes, and seconds.
- Sub-dials: Chronograph 24-hour time, minute stopwatch, and second stopwatch.
- Leather Strap: Secures the watch to your wrist.
Image: Front view of the Fastrack Big Time Quartz Chronograph Watch. Shows the black dial with three sub-dials, white hour markers, and hands. The crown and pushers are visible on the right side of the case.
Image: Side view of the watch case, highlighting the crown and the two pushers (red and black). The stainless steel case and part of the leather strap are visible.
Setup
Setting the Time
- Pull the crown out to the second click position.
- Rotate the crown to set the hour and minute hands to the correct time.
- Push the crown back into the normal position.
Adjusting the Strap
The watch features a leather strap with a buckle clasp. To adjust, simply thread the strap through the buckle and secure it at a comfortable fit on your wrist.
Operating the Chronograph
Your Fastrack watch is equipped with a chronograph function for measuring elapsed time.
Starting and Stopping the Chronograph
- Press the upper pusher (A) to start the chronograph. The chronograph second hand will begin to move.
- Press the upper pusher (A) again to stop the chronograph. The elapsed time will be indicated by the chronograph second, minute, and 24-hour sub-dials.
Resetting the Chronograph
- After stopping the chronograph, press the lower pusher (B) to reset all chronograph hands to their zero positions.
- Note: The chronograph must be stopped before it can be reset.
Maintenance and Care
Cleaning Your Watch
To maintain the appearance of your watch:
- Wipe the watch case and mineral glass with a soft, dry, clean cloth.
- For the leather strap, avoid prolonged exposure to water, direct sunlight, and harsh chemicals to prevent damage and discoloration.
Water Resistance
This watch is water resistant up to 50 meters (5 ATM). This means it is suitable for short periods of recreational swimming, but not for diving or snorkeling. Avoid operating the crown or pushers when the watch is wet or submerged in water.
Important: Water resistance is not a permanent condition and may eventually deteriorate. Always ensure the crown is fully pushed in to maintain water resistance.
Battery Replacement
The watch uses a quartz movement powered by a battery. When the watch stops or the second hand moves erratically, it indicates a low battery. Battery replacement should be performed by a qualified watch technician to ensure proper sealing and water resistance.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Watch stops or runs intermittently. | Low battery. | Replace the battery. Contact an authorized service center. |
| Chronograph hands do not reset to zero. | Chronograph was not stopped before resetting, or a calibration issue. | Ensure chronograph is stopped before pressing pusher B. If issue persists, consult the service center for calibration. |
| Moisture inside the watch. | Crown not fully pushed in, or seals compromised. | Immediately take the watch to an authorized service center to prevent further damage. |
Specifications
| Feature | Detail |
|---|---|
| Model Number | NP3072SL02 |
| Movement Type | Quartz |
| Display Type | Analog |
| Dial Color | Black with grey highlights |
| Case Material | Stainless Steel |
| Case Diameter | 48.25 mm |
| Dial Glass Material | Mineral Crystal |
| Band Material | Leather |
| Band Color | Black |
| Water Resistance Depth | 50 meters (5 ATM) |
| Item Weight | 120 g |
| Product Dimensions | 14 x 7 x 10 cm |
Image: Back view of the Fastrack watch, showing the stainless steel case back and the black leather strap with white stitching and a buckle clasp.
Warranty Information
Your Fastrack Big Time Quartz Chronograph Watch NP3072SL02 comes with a manufacturer's warranty:
- Manufacturer Warranty: 24 months from the date of purchase.
- Battery Warranty: 6 months from the date of purchase.
This warranty covers manufacturing defects. It does not cover damage resulting from improper use, accidents, unauthorized repairs, or normal wear and tear. Please retain your purchase receipt for warranty claims.
Support and Contact
For service, repairs, or further assistance, please contact Fastrack customer support:
- Manufacturer: Fastrack, Titan Company Ltd
- Address: 3 Sipcot Industrial Complex, Hosur - 635126, India
- Telephone: +91-(0)4344-664199
- You may also visit the official Fastrack Store on Amazon for more information.
Image: The Fastrack watch packaging, a black cylindrical can with the Fastrack logo.