Invacare Perfecto Platinum Intake Air HEPA Filter 1131249 User Manual

1. Introduction

This manual provides essential information for the proper installation, maintenance, and understanding of the Invacare Perfecto Platinum Intake Air HEPA Filter, model 1131249. This filter is designed to ensure optimal performance and air quality for compatible Invacare oxygen concentrators.

2. Product Overview

The Invacare Perfecto Platinum Intake Air HEPA Filter (Part Number 1131249) is a critical component for maintaining the purity of the air supplied by your Invacare Perfecto Platinum oxygen concentrator. It is a High-Efficiency Particulate Air (HEPA) filter, designed to capture microscopic particles from the intake air, protecting both the device and the user.

Image 1: Invacare Perfecto Platinum Intake Air HEPA Filter, model 1131249, sealed in its clear plastic packaging. An orange label on the filter indicates instructions for use on Platinum 10 and pre-Platinum models, with 'PEEL HERE' tabs.

3. Safety Information

• Always disconnect the oxygen concentrator from the power source before attempting any maintenance or filter replacement.
• Use only genuine Invacare replacement parts to ensure proper fit and performance.
• Do not attempt to clean or reuse a dirty HEPA filter; always replace it with a new one.
• Keep filters out of reach of children and pets.

4. Installation and Setup

Follow these steps to replace the intake air HEPA filter in your Invacare Perfecto Platinum oxygen concentrator:

1. Power Off: Ensure the oxygen concentrator is turned off and unplugged from the electrical outlet.
2. Locate Filter Compartment: Refer to your oxygen concentrator's main user manual to locate the intake air filter compartment. This is typically on the back or side of the unit.
3. Remove Old Filter: Carefully open the filter compartment and remove the old HEPA filter. Dispose of the old filter responsibly.
4. Prepare New Filter: The new filter may have a protective seal. As indicated on the filter packaging (refer to Image 1), if using on a Platinum 10 model, remove the specified part of the seal. If using on pre-Platinum models, remove the other specified part of the seal. Ensure the correct seal is removed for your specific concentrator model.
5. Insert New Filter: Insert the new Invacare HEPA filter into the compartment, ensuring it is seated correctly and securely.
6. Close Compartment: Close the filter compartment cover.
7. Restore Power: Plug the oxygen concentrator back into the electrical outlet and turn it on.

Note: Always consult your specific oxygen concentrator's user manual for detailed, model-specific filter replacement instructions.

5. Operation

Once installed, the Invacare Perfecto Platinum Intake Air HEPA Filter operates continuously as part of your oxygen concentrator's air purification system. It passively filters incoming air, removing particulates before they reach the internal components of the concentrator and the patient. No user interaction is required during its operation.

6. Maintenance

Regular replacement of the intake air HEPA filter is crucial for the longevity of your oxygen concentrator and the quality of the oxygen delivered. Invacare recommends the following maintenance schedule:

• Replacement Frequency: Replace the HEPA filter every 3 months, or more frequently if the operating environment is particularly dusty or if indicated by your oxygen concentrator's maintenance alerts.
• Inspection: Periodically inspect the filter for visible signs of dirt or blockage. A heavily soiled filter can restrict airflow and reduce concentrator efficiency.

Failure to replace the filter as recommended may lead to reduced performance of the oxygen concentrator and potential damage to internal components.

7. Troubleshooting

If you experience issues after replacing the filter, consider the following:

• Concentrator Not Starting: Ensure the concentrator is properly plugged in and the power switch is on. Verify the filter compartment cover is securely closed.
• Reduced Airflow/Performance: Check that the new filter is correctly seated and not obstructed. Ensure the correct seal was removed for your specific model as per installation instructions.
• Unusual Noises: Confirm all covers and filters are securely in place. Loose components can cause vibrations.

If problems persist, consult your oxygen concentrator's main user manual or contact Invacare customer support.

8. Specifications

9. Warranty and Support

For information regarding the warranty of your Invacare Perfecto Platinum Intake Air HEPA Filter or for technical support, please contact Invacare customer service directly. Refer to the documentation provided with your oxygen concentrator for specific contact details or visit the official Invacare website.

Invacare Website: www.invacare.com