Sunbeam Restful Quilted Heated Mattress Pad User Manual

1. Introduction

Thank you for choosing the Sunbeam Restful Quilted Heated Mattress Pad. This easy-to-use mattress pad is designed to provide personalized warmth and comfort. It features 12 heat settings, a 12-hour selectable auto-shut off function, and a soft, quilted polyester top for a cozy sleep experience. This manual provides essential information for the safe and effective use of your heated mattress pad.

2. Important Safety Information

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE OVERHEATING, FIRE, OR PERSONAL INJURY.

• Read all instructions carefully before use.
• Do not use on infants, invalids, paraplegics, quadriplegics, diabetics, helpless persons, or persons insensitive to heat, such as a person with poor blood circulation.
• Do not use on pull-out or fold-up beds.
• The heated mattress pad should never be folded, balled up, or bunched in any way when in use. This may result in overheating.
• Do not use pins.
• Do not dry clean.
• Do not bleach.
• Do not iron.
• Do not wring.
• If improper operation of this bedding is observed, discontinue its use immediately and consult the manufacturer or the dealer regarding its repair.
• Always disconnect the control unit from the mattress pad before washing.

3. Package Contents

• 1 x Sunbeam Restful Quilted Heated Mattress Pad (Queen Size)
• 2 x Digital Controllers (for Queen and King sizes)

4. Setup Instructions

1. Unpack the Mattress Pad: Carefully remove the mattress pad and controllers from the packaging.
2. Position the Mattress Pad: Place the heated mattress pad directly on your mattress with the quilted side facing up. Ensure it is spread evenly and smoothly across the mattress surface.
3. Secure the Mattress Pad: The mattress pad features an elastic fitted pocket designed to fit mattresses up to 18 inches deep. Stretch the elasticized skirt over the corners of your mattress to ensure a secure and snug fit.
4. Connect the Controllers: Locate the connection ports on the mattress pad, typically at the foot end. Plug each digital controller securely into its respective port. For Queen and King sizes, there are two controllers for independent heating zones.
5. Plug into Power: Plug the power cords from the controllers into a standard 120V AC electrical outlet. Ensure the cords are not pinched or trapped between the mattress and bed frame.

5. Operating Instructions

5.1. Controller Overview

Your Sunbeam heated mattress pad comes with a user-friendly digital controller. Queen and King sizes include two controllers, allowing each side of the bed to be heated independently.

5.2. Powering On/Off

• Press the Power button to turn the mattress pad on or off.
• The digital display will illuminate to show the current heat setting.

5.3. Adjusting Heat Settings

• Use the + and - buttons to cycle through the 12 available heat settings.
• Start with a lower setting and gradually increase until your desired comfort level is reached.

5.4. Auto Shut-Off Function

• The mattress pad features a built-in 12-hour selectable auto-shut off function for safety and peace of mind.
• To adjust the auto-off timer, refer to your controller's specific instructions.

5.5. Dual Controls (Queen/King Sizes)

For Queen and King size mattress pads, two individual controllers are provided. This allows each user to set their preferred heat level independently, ensuring personalized comfort without compromise.

6. Care and Maintenance

The Sunbeam Restful Quilted Heated Mattress Pad is designed for easy care and is machine washable and dryer safe.

1. Disconnect Controllers: Before washing, always disconnect and remove all digital controllers from the mattress pad.
2. Washing: Machine wash in cold water on a gentle cycle. Do not bleach.
3. Drying: Tumble dry on low heat. Remove promptly from the dryer to prevent excessive wrinkling. Stretch to original size and line dry to finish drying if needed. Do not iron.
4. Storage: Ensure the mattress pad is completely dry before storing. Store in a cool, dry place.

7. Troubleshooting

If your heated mattress pad is not functioning correctly, please refer to the following common issues and solutions:

• No Heat: Ensure the power cord is securely plugged into a working electrical outlet and the controller is firmly connected to the mattress pad. Press the power button on the controller.
• Uneven Heating: Ensure the mattress pad is spread flat and not bunched or folded. Uneven heating can occur if the internal wires are not properly distributed.
• Controller Display Not Working: Check power connections. If the issue persists, try plugging the controller into a different outlet.
• Automatic Shut-Off Too Soon: Verify the auto-shut off timer setting on your controller.

If these steps do not resolve the issue, discontinue use and contact customer support.

8. Specifications

9. Official Product Video

10. Warranty and Support

This Sunbeam Restful Quilted Heated Mattress Pad comes with a Limited 5-year Warranty. For warranty claims, product support, or further assistance, please contact Sunbeam customer service through their official website or the contact information provided with your product packaging.