Franke PR-36S Prestige Series Sink Bottom Grid Instruction Manual

Introduction

This manual provides instructions for the Franke PR-36S Prestige Series Sink Bottom Grid. This product is designed to protect your sink's base from scratches and provide a stable surface for various kitchen tasks. It is constructed from durable stainless steel and features protective rubber feet and side bumpers.

Image: Franke PR-36S Prestige Series Sink Bottom Grid, showcasing its full stainless steel construction.

1. Setup

The Franke PR-36S Sink Bottom Grid is designed for easy placement within compatible Franke Prestige Stainless Steel sinks. No assembly is required.

1.1 Placement

1. Carefully unpackage the sink grid.
2. Ensure the sink basin is clean and free of debris.
3. Place the grid into the bottom of your Franke Prestige Series sink. The grid is designed to fit precisely, covering the entire base.
4. Verify that the rubber feet and side bumpers are properly positioned to elevate the grid and prevent direct contact with the sink surface.

Image: Close-up view of a corner of the sink grid, highlighting the protective rubber feet and side bumpers.

2. Operating Instructions

The sink bottom grid serves to protect your sink and provide a functional surface during daily kitchen activities.

• Sink Protection: The grid's stainless steel construction and elevated design protect the sink's base from scratches and impacts from dishes, pots, and pans.
• Stable Surface: Use the grid as a stable surface for washing dishes, preparing food, or air-drying items.
• Efficient Drainage: The open grid design allows for efficient water drainage, preventing standing water in the sink basin.

Image: An elevated view of the Franke PR-36S sink grid, demonstrating its structure for optimal use.

3. Maintenance and Care

Regular cleaning and maintenance will ensure the longevity and appearance of your Franke PR-36S Sink Bottom Grid.

3.1 Cleaning

1. Remove the grid from the sink.
2. Wipe the grid with a dry cloth after each use to prevent water spots and mineral buildup.
3. For deeper cleaning, wash the grid with mild soap and warm water. A soft brush can be used to clean between the wires.
4. The stainless steel grid is dishwasher safe for thorough sanitization.
5. Avoid using abrasive cleaners, steel wool, or harsh chemicals, as these can damage the stainless steel finish.

3.2 Preventing Stains and Buildup

• Rinse the grid thoroughly after contact with acidic foods or strong cleaning agents.
• Periodically check the rubber feet and side bumpers for wear and tear.

Image: Detailed view of the Franke PR-36S sink grid's wire pattern, illustrating its robust construction.

4. Troubleshooting

4.1 Grid Wobbles or Does Not Sit Evenly

If the grid wobbles or does not sit evenly in the sink:

• Ensure all rubber feet are present and properly attached.
• Check for any debris under the grid or in the sink basin that might be preventing it from sitting flat.
• Verify that the grid model (PR-36S) is compatible with your specific Franke Prestige Series sink model.

4.2 Difficulty Cleaning / Stains

If the grid is difficult to clean or shows signs of staining:

• Refer to the 'Maintenance and Care' section for recommended cleaning procedures.
• Ensure you are not using abrasive materials or harsh chemicals that could cause discoloration or damage.
• For stubborn stains, a stainless steel cleaner specifically designed for kitchen use may be applied, following the product's instructions.

5. Specifications

6. Warranty Information

Specific warranty details for the Franke PR-36S Prestige Series Sink Bottom Grid are typically provided with the product packaging or can be obtained directly from Franke's official website or customer service. Please retain your proof of purchase for warranty claims.

7. Customer Support

For further assistance, technical support, or to inquire about replacement parts, please contact Franke customer service.

• Website: www.franke.com
• Phone: Refer to Franke's official website for regional contact numbers.