Introduction
This manual provides essential instructions for the safe and effective use of your Accu-Cable EC123-3FER50 12 Gauge 50 Ft Extension Cable. Please read this manual thoroughly before use and retain it for future reference.
This image displays the Accu-Cable EC123-3FER50 extension cable. The cable is coiled and secured with a band indicating '50 FEET (15.24M)'. The packaging also highlights 'Indoor/Outdoor General Purpose' and 'ac extension cord'. To the right, the male plug and the triple-tap female connector are shown, illustrating the cable's ends. Key specifications like '3-wire - 12 gauge Edison extension cord', 'Maximum Amps: 20', 'Maximum Volts: 125', and 'Maximum Watts: 2400' are visible on the packaging.
Important Safety Warnings
WARNING: Misuse of extension cords can result in fire, electric shock, or personal injury. Always follow these safety guidelines:
- Do not exceed the maximum electrical ratings of the cable.
- Do not remove or modify the ground pin on the plug.
- Do not use damaged cords. Inspect the cable for cuts, fraying, or exposed wires before each use.
- Keep away from water and moisture unless specifically rated for wet conditions. While this cable is rated for outdoor use, avoid submerging connections.
- Unplug the cable from the power source when not in use.
- Keep out of reach of children.
- Do not run the cable through doorways, under carpets, or in areas where it can be pinched or damaged.
- Ensure all connections are secure and fully inserted.
Setup
- Unpacking: Carefully remove the extension cable from its packaging. Inspect the cable and connectors for any signs of damage. If damage is found, do not use the cable.
- Placement: Position the cable to avoid tripping hazards. Ensure it is not pinched, kinked, or subjected to excessive strain.
- Connection to Power Source: Plug the male end of the extension cable into a compatible grounded electrical outlet. Ensure the connection is firm and fully seated.
- Device Connection: Plug your device(s) into the triple-tap female end of the extension cable. Verify that the total power consumption of all connected devices does not exceed the cable's maximum ratings (20 Amps, 125 Volts, 2400 Watts).
Operating
The Accu-Cable EC123-3FER50 is designed for general purpose indoor and outdoor use. Its 12-gauge construction and ETL approval ensure reliable power delivery.
- Indoor Use: Suitable for powering various electrical appliances and tools within indoor environments.
- Outdoor Use: The cable is UV resistant and designed for outdoor environments. However, always ensure that all connections are protected from direct rain, standing water, or excessive moisture to prevent electrical hazards.
- Load Capacity: This cable supports a maximum of 20 Amps, 125 Volts, and 2400 Watts. It is critical not to overload the cable by connecting devices that collectively exceed these limits. Overloading can cause overheating, fire, or damage to equipment.
- Cable Management: Utilize the included Velcro cable tie wrap for neat storage and to prevent tangling when not in use or during transport.
Maintenance
- Cleaning: Always disconnect the cable from all power sources before cleaning. Wipe the cable and connectors with a dry, clean cloth. Do not use harsh chemicals, solvents, or abrasive cleaners, as these can damage the insulation or connectors.
- Storage: When not in use, coil the cable neatly using the Velcro tie wrap. Store it in a cool, dry place, away from direct sunlight, extreme temperatures, and corrosive materials. Avoid storing it in a tangled state, which can lead to kinks and damage.
- Inspection: Regularly inspect the entire length of the cable for any signs of wear, cuts, fraying, cracks in the insulation, or damage to the plugs and receptacles. If any damage is found, discontinue use immediately and replace the cable to prevent electrical hazards.
Troubleshooting
If you encounter issues with your Accu-Cable extension cord, refer to the following troubleshooting steps:
- No Power to Device:
- Ensure the extension cable is securely plugged into a working electrical outlet.
- Verify that the device is properly plugged into the extension cable's receptacle.
- Check the circuit breaker or fuse for the outlet. Reset if tripped.
- Test the device directly in a known working outlet to rule out device malfunction.
- Inspect the extension cable for visible damage. If damaged, do not use.
- Overheating:
If the cable or its connectors feel excessively warm to the touch, immediately unplug all devices and the cable from the power source. This indicates an overload. Reduce the number of connected devices or use a higher-rated extension cord suitable for your power requirements.
If problems persist after following these steps, discontinue use and contact customer support.
Specifications
| Feature | Detail |
|---|---|
| Brand | Accu-Cable |
| Model | EC123-3FER50 |
| Cable Type | Extension Cable, 3-prong |
| Wire Gauge | 12 AWG (American Wire Gauge) |
| Length | 50 Feet (15.24 Meters) |
| Connector Type | 3 Prong Edison (Male to Triple Tap Female) |
| Maximum Amps | 20A |
| Maximum Volts | 125V |
| Maximum Watts | 2400W |
| Indoor/Outdoor Usage | Yes |
| Special Feature | UV Resistant |
| Certification | ETL Approved |
| Color | Black |
| Item Weight (approx.) | 1 Pound |
| Manufacturer | American DJ Group of Companies |
Warranty and Support
For warranty information or technical support regarding your Accu-Cable EC123-3FER50 extension cable, please refer to the manufacturer's official website or contact their customer service department directly. The manufacturer is American DJ Group of Companies.
It is recommended to retain your purchase receipt as proof of purchase for any warranty claims.