Introduction
This manual provides essential information for the safe and effective use of Varta Industrial AA Alkaline Batteries. Please read these instructions carefully before use and retain them for future reference. These batteries are designed for a wide range of devices requiring AA (Mignon) size alkaline power.
This image displays a pack of four Varta Industrial AA Alkaline Batteries. Each battery is cylindrical, primarily blue with a yellow top. The Varta logo and 'INDUSTRIAL PRO' are printed vertically on the blue section. The yellow top features a prominent '+' symbol indicating the positive terminal, and 'AA LR6 1.5V' is also visible, specifying the battery type and voltage.
Setup
- Identify Battery Compartment: Locate the battery compartment on your electronic device. This is typically found on the back, bottom, or side of the device.
- Open Compartment: Open the battery compartment cover. This may involve sliding, lifting, or unscrewing.
- Observe Polarity: Inside the compartment, observe the polarity markings (+ and -). These indicate the correct orientation for battery insertion.
- Insert Batteries: Insert the Varta Industrial AA Alkaline Batteries according to the polarity markings. The positive (+) end of the battery should align with the positive (+) terminal in the compartment, and the negative (-) end with the negative (-) terminal.
- Close Compartment: Securely close the battery compartment cover.
Note: Always ensure the device is turned off before installing or replacing batteries.
Operating
Varta Industrial AA Alkaline Batteries are designed for single-use applications and provide reliable power for a wide range of electronic devices. Once installed correctly, the device should function as intended.
- Powering Devices: These batteries are suitable for remote controls, toys, flashlights, clocks, and various small household or office appliances.
- Performance: Expect consistent voltage output until the battery is depleted. Performance may vary based on device power consumption and usage patterns.
- Replacement: Replace all batteries in a device at the same time to ensure optimal performance and prevent issues caused by mixed battery levels.
Maintenance and Safety
Proper handling and storage extend battery life and ensure safety.
- Storage: Store batteries in a cool, dry place at room temperature, away from direct sunlight and extreme temperatures. Keep them in their original packaging until ready for use.
- Handling: Do not short-circuit, recharge, disassemble, or expose batteries to fire or water. Doing so can cause leakage, rupture, or explosion.
- Mixing Batteries: Do not mix new and used batteries, or batteries of different types or brands, as this can lead to leakage or reduced performance.
- Disposal: Dispose of used batteries responsibly according to local regulations. Many communities offer battery recycling programs. Do not dispose of batteries in household waste.
- Children and Pets: Keep batteries out of reach of small children and pets to prevent accidental ingestion. If a battery is swallowed, seek immediate medical attention.
- Leakage: If battery leakage occurs, avoid contact with skin and eyes. If contact occurs, rinse immediately with plenty of water and seek medical advice. Clean the device's battery compartment thoroughly before inserting new batteries.
Troubleshooting
If your device is not functioning correctly after installing new batteries, consider the following:
- Device Not Powering On:
- Verify correct battery polarity (+ and -).
- Ensure batteries are fully inserted and making proper contact with the terminals.
- Check if the device itself is functioning by testing with another set of known good batteries.
- Shortened Battery Life:
- Ensure all batteries in the device are new and from the same pack.
- High-drain devices will deplete batteries faster. Consider the device's power requirements.
- Check for any device malfunctions that might be causing excessive power draw.
- Battery Leakage:
- Leakage can occur if batteries are left in a device for extended periods after depletion, or due to extreme temperatures.
- Remove depleted batteries promptly.
- Follow safety guidelines for cleaning up leaked material (see Maintenance and Safety).
Specifications
| Feature | Specification |
|---|---|
| Battery Type | Alkaline |
| Battery Size | AA / Mignon (LR6) |
| Voltage | 1.5 Volt |
| Capacity | 2600 mAh (Milliamp Hours) |
| Item Weight (per battery) | Approximately 23.5 grams (0.83 ounces) - based on 94g for 4 batteries |
| Product Dimensions (per battery) | Approximately 1.57 x 0.59 x 0.59 inches (40 x 14.5 x 14.5 mm) |
| Model Number | 04006 211 354 |
| Manufacturer | Varta |
Warranty Information
Varta Industrial AA Alkaline Batteries are manufactured to high-quality standards. For specific warranty details, please refer to the packaging or contact Varta customer support directly. Generally, alkaline batteries are covered against manufacturing defects for a limited period. Damage resulting from improper use, storage, or handling is typically not covered.
Support
For further assistance, technical inquiries, or information regarding Varta products, please visit the official Varta website or contact their customer service department. Contact details can usually be found on the product packaging or the Varta corporate website.
Please have the product model number (04006 211 354) available when contacting support.
