BAYCO SL-450

Bayco SL-450 Retractable Utility Light User Manual

Model: SL-450

1. Introduction

The Bayco SL-450 is a durable retractable utility light designed for various task lighting applications. It features an impact-resistant engineered polymer reel housing, a galvanized metal lamp shield with a rubber-tipped hands-free hook, and a polarized plug with a 7-amp grounded receptacle. This unit also includes a 7-amp resettable circuit breaker and a durable ON/OFF switch. It is rated for use with an incandescent bulb up to 75 watts (bulb not included).

Bayco SL-450 Metal Shield Incandescent Utility Light with Grounded Receptacle on 20 Foot Retractable Reel, Yellow

Figure 1: Bayco SL-450 Retractable Utility Light. This image shows the yellow retractable reel and the utility light with its metal shield and handle.

2. Safety Information

Read and understand all safety instructions before using this product. Failure to follow these instructions may result in electric shock, fire, or serious injury.

  • Electrical Safety: Always plug the unit into a properly grounded 3-prong outlet. Do not remove the grounding prong. Do not use with ungrounded adapters.
  • Bulb Compatibility: Use only incandescent bulbs rated up to 75 watts. Exceeding this wattage can cause overheating and fire. Ensure the bulb is securely installed before use.
  • Environmental Conditions: Do not expose the unit to rain or wet conditions. This product is intended for indoor or dry outdoor use.
  • Cord Care: Inspect the cord for damage before each use. Do not use if the cord is frayed, cut, or damaged. Avoid pulling the cord sharply or kinking it.
  • Overload Protection: The unit features a 7-amp resettable circuit breaker. If the light or connected device stops working, check the circuit breaker. Do not bypass or tamper with the circuit breaker.
  • Proposition 65 Warning: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.

3. Setup

3.1 Mounting the Reel

The Bayco SL-450 comes with mounting brackets for secure installation. Choose a sturdy location, such as a ceiling joist or wall stud, that can support the weight of the unit and the force of cord retraction. Ensure the mounting location allows for full extension and retraction of the 20-foot cord without obstruction.

  1. Position the reel at the desired mounting location.
  2. Mark the drilling points through the mounting holes on the reel bracket.
  3. Drill pilot holes if necessary, appropriate for your mounting hardware (not included).
  4. Securely fasten the reel to the surface using appropriate screws or bolts.

3.2 Bulb Installation

The incandescent bulb is not included with the unit.

  1. Ensure the unit is unplugged from any power source before installing the bulb.
  2. Unscrew the galvanized metal lamp shield by rotating it counter-clockwise.
  3. Carefully screw in an incandescent bulb, up to a maximum of 75 watts, into the socket. Do not overtighten.
  4. Reattach the metal lamp shield by rotating it clockwise until secure.

4. Operation

4.1 Extending and Retracting the Cord

To extend the cord, gently pull the light assembly away from the reel. The cord will lock at various intervals. To retract the cord, pull the light assembly slightly further out until you hear a click, then slowly guide the cord back into the reel. Do not release the cord abruptly, as this can cause damage to the retraction mechanism.

Video 1: Product Overview. This video provides an overview of the Bayco SL-450 retractable utility light, demonstrating its features and functionality, including cord extension and retraction.

4.2 Using the Light

Once the unit is plugged into a grounded outlet and a bulb is installed, use the durable ON/OFF switch located on the handle of the light assembly to turn the light on or off.

4.3 Using the Grounded Receptacle

The light assembly includes a 7-amp grounded receptacle. This allows you to power other small tools or devices directly from the utility light. Ensure that the total current draw of any connected devices does not exceed 7 amps to prevent tripping the circuit breaker.

5. Maintenance

5.1 Cleaning

Always unplug the unit before cleaning. Wipe the exterior surfaces with a damp cloth. Do not use abrasive cleaners or solvents. Ensure the unit is completely dry before plugging it back in.

5.2 Bulb Replacement

Refer to Section 3.2 for bulb installation instructions. Always ensure the unit is unplugged and the bulb has cooled down before attempting to replace it.

5.3 Cord Care

Periodically inspect the entire length of the cord for any signs of wear, cuts, or damage. If damage is found, discontinue use immediately and replace the unit. When retracting the cord, guide it gently to prevent tangling or binding within the reel mechanism.

6. Troubleshooting

ProblemPossible CauseSolution
Light does not turn on.
  • No power to outlet.
  • Bulb is burnt out or loose.
  • Circuit breaker tripped.
  • ON/OFF switch is off.
  • Check power outlet with another device.
  • Replace bulb or ensure it is screwed in tightly.
  • Press the reset button on the circuit breaker.
  • Ensure the ON/OFF switch is in the 'ON' position.
Cord does not retract smoothly or binds.
  • Cord is tangled or kinked.
  • Retraction mechanism obstruction.
  • Pull the cord out completely, then guide it back slowly and evenly.
  • Ensure no debris is obstructing the reel opening.
Circuit breaker trips frequently.
  • Overload on the grounded receptacle.
  • Faulty bulb or internal wiring issue.
  • Reduce the load on the grounded receptacle; ensure total draw is under 7 amps.
  • Replace the bulb. If the issue persists, discontinue use and contact support.

7. Specifications

  • Brand: BAYCO
  • Model Number: SL-450
  • Material: Polypropylene (Reel Housing), Galvanized Metal (Lamp Shield)
  • Color: Yellow
  • Item Dimensions (L x W x H): 9.25 x 11.25 x 3.5 inches
  • Item Weight: 1.5 kg
  • Cord Length: 20 feet
  • Maximum Bulb Wattage: 75 watts (incandescent)
  • Receptacle Rating: 7 Amp Grounded
  • Circuit Breaker: 7 Amp Resettable
  • UPC: 017398100021
  • Included Components: Light with Reel & Mounting brackets

8. Warranty & Support

8.1 Warranty Information

This Bayco SL-450 utility light is covered by a 1 Year Limited Warranty from the date of purchase. This warranty covers defects in materials and workmanship under normal use. It does not cover damage resulting from misuse, abuse, accidents, unauthorized repairs, or modifications.

For full warranty details and to make a claim, please refer to the official Bayco Products Inc. warranty documentation or contact their customer support.

8.2 Customer Support

If you have any questions, require technical assistance, or need to report a problem with your Bayco SL-450 utility light, please contact Bayco Products Inc. customer support. Contact information can typically be found on the manufacturer's official website or on the product packaging.

Please have your model number (SL-450) and proof of purchase ready when contacting support.

© 2024 BAYCO Products Inc. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.