1. Introduction
The Moen 20200 Swing'N'Spray Aerator is designed to enhance the functionality of your kitchen or bathroom faucet. It features a 360-degree swivel for flexible water direction and offers both aerated stream and spray options. This aerator is engineered for efficiency with a 2.2 Gallons Per Minute (GPM) flow rate and includes an adapter kit for broad compatibility.
Image of the Moen 20200 Swing'N'Spray Aerator, showing its main components and design.
2. Setup and Installation
2.1. What's Included
- Moen 20200 Swing'N'Spray Aerator
- Adapter Kit (for various faucet thread sizes)
- Washers/Gaskets
2.2. Installation Instructions
- Turn off Water Supply: Locate and turn off the water supply valves to the faucet where the aerator will be installed.
- Remove Existing Aerator: If an old aerator is present, unscrew it from the faucet spout. You may need a wrench for stubborn aerators.
- Clean Faucet Spout: Clean any debris or mineral buildup from the threads of the faucet spout.
- Select Adapter (if needed): The Moen 20200 includes an adapter kit. Determine if your faucet requires an adapter for proper fit.
- Insert Washer/Gasket: Place the appropriate washer or gasket into the aerator or adapter. Ensure it is seated correctly to prevent leaks.
- Attach Aerator: Screw the Moen 20200 aerator (with or without the adapter) onto the faucet spout. Hand-tighten first, then use a wrench for a snug fit, being careful not to overtighten.
- Check for Leaks: Turn the water supply back on and check for any leaks around the aerator connection. If a leak occurs, tighten slightly or re-seat the washer.
Close-up view of the Moen 20200 Swing'N'Spray Aerator components, including the aerator head, adapter, and washer.
3. Operation
The Moen 20200 Aerator offers versatile water delivery:
- Swivel Function: The aerator head can swivel 360 degrees, allowing you to direct the water flow precisely where needed in the sink.
- Stream and Spray Modes: To switch between the aerated stream and the wide spray pattern, gently pull down or push up on the aerator head. This allows for efficient rinsing and cleaning tasks.
- Flow Rate: The aerator provides a consistent water flow of 2.2 Gallons Per Minute (GPM).
4. Maintenance
Regular maintenance ensures optimal performance and extends the life of your aerator.
- Cleaning the Aerator Screen: Over time, mineral deposits and debris can accumulate in the aerator screen, reducing water flow. To clean, unscrew the aerator from the faucet spout. Carefully remove the screen and rinse it under running water. A soft brush can be used to dislodge stubborn particles. Reassemble and reattach the aerator.
- Checking for Leaks: Periodically inspect the connection point between the aerator and the faucet spout for any signs of leakage. If a leak is detected, ensure the aerator is securely tightened. If the leak persists, the internal washer or gasket may need to be replaced.
5. Troubleshooting
Refer to the following common issues and their solutions:
- Low Water Flow:
- Cause: Clogged aerator screen due to mineral buildup or debris.
- Solution: Remove and clean the aerator screen as described in the Maintenance section. Ensure water supply valves are fully open.
- Leaking at Connection Point:
- Cause: Aerator not tightened sufficiently or damaged/improperly seated washer/gasket.
- Solution: Ensure the aerator is securely tightened. If the leak persists, remove the aerator, inspect the washer/gasket for damage, and replace if necessary. Re-seat the washer properly.
- Difficulty Swiveling:
- Cause: Mineral buildup around the swivel mechanism.
- Solution: Remove the aerator and clean the swivel components thoroughly to remove any mineral deposits.
6. Specifications
| Feature | Detail |
|---|---|
| Brand | Moen |
| Model Number | 20200 |
| Maximum Flow Rate | 2.2 Gallons Per Minute |
| Thread Size | 15/16-27 |
| Item Weight | 1.6 ounces |
| Product Dimensions | 4.75 x 3.62 x 2.25 inches |
| Finish Type | Unfinished |
| Specification Met | NSF 61 |
| Included Components | Replacement Parts or Service Kit |
7. Warranty Information
The Moen 20200 Swing'N'Spray Aerator is covered by a 1-Year Limited Warranty. This warranty typically covers defects in material and manufacturing under normal use. For complete details regarding coverage, terms, and conditions, please refer to the official Moen warranty documentation provided with your purchase or visit the Moen official website.
8. Customer Support
Should you require further assistance, technical support, or need to make a warranty claim, please contact Moen customer service. It is recommended to have your product model number (20200) and proof of purchase readily available when contacting support.
You can typically find contact information for Moen customer service on their official website: www.moen.com
