Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your Hunter 27183 Traditional Wall Control with Preset. Please read these instructions carefully before installation and use to ensure proper function and safety.
The Hunter 27183 wall control is designed to provide four fan speeds and full-range light dimming for your ceiling fan. It includes a preset feature to control fan and light operation at desired settings.
Safety Information
- Always disconnect power at the circuit breaker or fuse box before beginning installation or performing any maintenance.
- Installation must be performed by a qualified electrician or in accordance with local electrical codes.
- Ensure all wiring connections are secure and properly insulated.
- Do not exceed the specified electrical ratings: Fan 1.6 Amps, Light 300 Watts.
- This control is designed for indoor use only.
Package Contents
Verify that all components are present before beginning installation:
- Hunter 27183 Wall Control Unit
- Installation Hardware (screws, wire nuts)
- Instruction Manual
Note: A rocker switchplate is not included and must be purchased separately.
Setup and Installation
The Hunter 27183 wall control is designed for installation in a standard three-wire, single box wall switch. Professional installation is recommended.
- Turn off Power: Before starting, ensure power is disconnected at the circuit breaker or fuse box to avoid electrical shock.
- Remove Existing Switch: Carefully remove the existing wall switch from the wall box. Disconnect the wires, noting their connections.
- Wire Connections: Connect the wires from the wall box to the Hunter 27183 wall control according to the wiring diagram provided with the unit. Typically, this involves connecting the Line (hot) wire, Load (fan/light) wires, and Ground wire. Ensure all connections are secure using wire nuts.
- Mount Control: Gently push the wired control into the wall box. Secure the control to the wall box using the provided screws.
- Install Switchplate: Attach a compatible rocker switchplate (not included) over the control.
- Restore Power: Turn power back on at the circuit breaker or fuse box.
Figure 1: Front view of the Hunter 27183 Wall Control, showing the fan speed and light dimmer sliders.
Figure 2: Side view of the Hunter 27183 Wall Control, illustrating the compact design for in-wall installation.
Operating Instructions
The Hunter 27183 wall control features separate sliders for fan speed and light dimming, along with a preset function.
- Fan Speed Control: Use the fan slider to select one of the four available fan speeds. Move the slider up for higher speeds and down for lower speeds.
- Light Dimming: Use the light slider to adjust the brightness of your ceiling fan light. Move the slider up to increase brightness and down to dim the light.
- Preset Feature: The control includes a preset function. Once you have set your desired fan speed and light level, you can use the main rocker switch (if present on your switchplate) to turn the fan and light on/off at these preset settings without readjusting the sliders.
General Ceiling Fan Operation
Understanding how your ceiling fan operates in different seasons can help optimize comfort and energy savings when used with your Hunter wall control.
Figure 3: In summer, set your ceiling fan blades to rotate counter-clockwise. This creates a downward airflow, producing a wind-chill effect that can make a room feel cooler, allowing you to set your thermostat higher.
Figure 4: In winter, set your ceiling fan blades to rotate clockwise at a low speed. This draws warm air trapped near the ceiling down into the living space, helping to warm the room and potentially lowering heating costs.
Maintenance
The Hunter 27183 wall control requires minimal maintenance.
- Cleaning: To clean the surface of the control, wipe with a soft, damp cloth. Do not use abrasive cleaners or solvents. Ensure power is off before cleaning.
- Inspection: Periodically check the control for any signs of damage or loose connections. If any issues are found, disconnect power and consult a qualified electrician.
Troubleshooting
If you experience issues with your Hunter 27183 wall control, refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Fan or Light does not turn on. | No power to the control; loose wiring; faulty fan/light. | Check circuit breaker. Ensure all wiring connections are secure. Test fan/light directly if possible. |
| Light does not dim. | Incompatible light bulbs; faulty dimmer. | Ensure light bulbs are dimmable. Replace faulty dimmer if necessary. |
| Fan speeds are inconsistent. | Loose wiring; incompatible fan motor. | Check wiring connections. Verify fan compatibility with the control. |
If troubleshooting steps do not resolve the issue, contact Hunter customer support or a qualified electrician.
Specifications
| Feature | Detail |
|---|---|
| Model Number | 27183 |
| Brand | Hunter |
| Dimensions | 4.123" x 2.876" x 1.75" (Product); 38.1 x 45.72 x 19.56 cm (Package) |
| Fan Amperage | 1.6 Amps |
| Light Wattage | 300 Watts |
| Power Source | AC |
| Voltage | 120 Volts |
| Mounting Type | Wall Mount |
| Switch Style | Slide switch |
| Special Features | Preset Dual Slide Fan/Light Control |
| Material | Metal, Plastic |
| Item Weight | 136 g (0.3 Pounds) |
| UPC | 049694271839 |
| Manufacturer | Hunter Fan Company |
Warranty Information
The Hunter 27183 Wall Control is covered by a 1-year manufacturer's warranty from the date of purchase. This warranty covers defects in materials and workmanship under normal use. Please retain your proof of purchase for warranty claims.
For full warranty terms and conditions, please refer to the official Hunter website or contact customer support.
Customer Support
If you have any questions, require assistance with installation, or need to make a warranty claim, please contact Hunter customer support.
- Website: Visit the official Hunter Fan Company website for FAQs, support resources, and contact information.
- Phone: Refer to the packaging or Hunter's website for customer service phone numbers.
