Computer Mount
“
Product Information
Specifications:
- Compatible with: Garmin and Wahoo computers
- Tools Required: 4MM allen key, 5MM allen key, 2.5MM allen
key
Product Usage Instructions
1. Removal of Bolts and Insert:
- Use the 2.5mm allen key to remove the 2 small bolts from the
mount. - To remove the plastic insert, push the top cap bolt
upwards.
2. Mounting the Computer Mount:
- Use a 5mm allen key to remove the top cap from your bike and
loosen the stem steerer bolts. - Ensure your steerer tube sits approximately 3mm lower than the
top of the stem or top headset spacer. - Place the top cap computer mount on the bike and tighten the
bolt with a 4mm allen key. Make sure the cutouts in the mount are
placed at 6 and 9 o’clock. - Tighten the stem steerer bolts and place the plastic insert on
the top cap, orientating it based on your computer – vertically for
Garmin and horizontally for Wahoo.
3. Final Steps:
Finish by refitting and tightening the two small screws using
the 2.5mm hex key. Ensure the setup matches your specific computer
model.
FAQ
Q: Can I use this mount with other computer brands besides
Garmin and Wahoo?
A: The Ascend Components Computer Mount is specifically designed
for Garmin and Wahoo computers for optimal compatibility and fit.
We do not recommend using it with other brands.
Q: How do I adjust the angle of my computer when mounted on
this mount?
A: The angle of your computer display can be adjusted by
orienting the plastic insert accordingly – vertically for Garmin
and horizontally for Wahoo.
“`
How to fit the Ascend Components Computer Mount
Thank you for purchasing an Ascend Components Computer Mount. The guide will take you through a few basic steps to ensure you orientate the mount correctly. The mounts are compatible with both Garmin and Wahoo computers but require a slightly different set up depending on which computer you have.
Tools Required: 4MM allen key, 5MM allen key, 2.5MM allen key
1. Remove the 2 small bolts from the mount using the 2.5mm allen key
2. Remove the plastic insert by pushing the top cap bolt upwards
3. Remove the top cap from your bike with a 5mm allen key and loosen your stem steerer bolts. Check your steerer tube sits approximately 3mm lower than the top of the stem or top headset spacer.
4. Place your top cap computer mount on to the bike and tighten the bolt with a 4mm allen key. IMPORTANT – the 2 cutouts in the mount should be placed at 6 and 9 o’clock.
5. Tighten your stem steerer bolts and place the plastic insert on to your top cap. Orientate the insert depending on your computer. Garmin orientated vertically and Wahoo orientated horizontally.
GARMIN
WAHOO
6. Finish by refitting and tightening the two small screws using the 2.5mm hex key. In the example below we have it set up for a Garmin mount.
Documents / Resources
 |
ASCEND components Computer Mount [pdf] Instruction Manual Computer Mount, Computer, Mount |