Anolis ArcSource Submersible II Submersible Fixture LED Light

INSTALLATION INSTRUCTIONS

ARCSOURCE SUBMERSIBLE II

Fixture must be installed by a qualified electrican in accordance with all national and local electrical and construction codes and regulations. This device falls under class one and must be grounded! The unit is intended only for permanent underwater installation up to depth of 10 m.

 

STEP 1.A
INSTALLATION WITH STANDARD MOUNTING BRACKETS

1. Drill 2 holes to the surface according to brackets spacing.
   
2. Release locking screw on each sides. Angle fixture to desired position and tighten locking screw on each sides.
   

STEP 1.B

INSTALLATION WITH FLOOR STAND

1. Use fasteners that are a_ appropriate for use with your mounting surface.
   
   Drill 4 holes to the surface according to brackets spacing.
2. Attach floor stand to fixture with supplied bolt, washer, and cap nut.
   
3. Release locking screw on each side. Angle fixture to desired position and tighten locking screw on each sides.
   

CUSTOMER SUPPORT

QR code for Installations Instructions

ROBE lighting s. r. o. | Palackeho 416 | 757 01 Valasske Mezirici | Czech Republic | Tel.: +420 571 751 500 | E-mail: info@anolis.eu | www.anolislighting.com

VERSION 2.0 / 2_2023

Documents / Resources

	Anolis ArcSource Submersible II Submersible Fixture LED Light [pdf] Instruction Manual ArcSource Submersible II, Submersible Fixture LED Light, ArcSource Submersible II Submersible Fixture LED Light, Fixture LED Light, LED Light
	Anolis ArcSource Submersible II [pdf] User Manual ArcSource Submersible II, ArcSource II, Submersible II, Submersible

References

• User Manual