ANKER PowerConf User Manual

Anker PowerConf
User Manual

At a Glance

1	Multi-function button	8	Power button
2	Volume down button	9	Bluetooth button
3	Mute button	10	Bluetooth LED
4	Phone call button	11	USB port (Type-A) for charge-out
5	Volume up button	12	Audio output port
6	Status LED	13	USB port (Type-C) for charge-in
7	Power LED

Connecting

a) Connect to your PC by using a USB-C cable

b) Connect to your PC or mobile device via Bluetooth pairing
When powered on for the first time, PowerConf S3 will automatically enter the Bluetooth pairing mode.

	Press	Enter pairing mode
	Flashes blue	Bluetooth pairing
	Steady blue	Bluetooth connected

• Each time you power on PowerConf S3, it will automatically connect with the last successfully connected device if available.
• To disconnect Bluetooth, press the Bluetooth button again.

Powering On/Off

Press and hold the power button for 2 seconds to power on. The status LED will light on clockwise and then fade out.
To power off, press and hold the power button for 2 seconds.

	Steady white	Power on
	Light off	Power off

• Once connected to your computer, it will automatically power on.
• It will automatically power off after 30 minutes of inactivity or no source.

Button Controls

	Press or press and hold	Volume up/down
	Press	Answer/End a call
	Press and hold for 2 seconds	Reject a call
	Press	Mute or restore the microphone
	Press	Play/Pause music

Status LED behaviors

Lights up white for 2 seconds	Connected to power or PC
Breathes green	Coming call
Lights up blue partly	Sound direction detected
Lights up blue clockwise or counterclockwise	Increase or decrease volume
Turns red	Muted
Lights up green	Press the Power button to check the battery level

Charging
a) Charging this product

Steady red	Being charged
Steady white	Fully charged
Flashes red	Low battery

b) Charging an external device
• When powered off or being charged, it won’t charge out.
• When the remaining battery is less than 30%, the charge out current will be 5V 1A; if less than 10%, it won’t charge out.

Audio Output

Connect an external speaker to the AUX OUT port of PowerConf S3 by using an AUX cable (not provided). The audio will be played through the speaker.

Soundcore App

Download the Soundcore App for software updates.

Specifications

Specifications are subject to change without notice.

Charge input	5V  2A
Charge out	5V  2.1A
Rated output power	3W RMS
Battery capacity	6700 mAh
Charging time	4 hours
Talktime	24 hours
Driver size	1 x 1.75” (full range)
Frequency response	20 Hz – 20 kHz
Bluetooth version	V 5.0
Bluetooth range	10 m / 33 ft