ALPSALPINE DM-65C-G Component Speaker System User Guide
Using Instruction
CONTENTS
WOOFER INSTALLATION
TWEETER INSTALLATION
WIRING WIRING CONNECTION
Connection diagram of original car player
Schematic diagram of power amplifier connection
Original engine or Alpine Media player (Sold separately)
External power amplifier (Sold separately)
EXTERNAL DIMENSIONS
SPECIFICATIONS
- Units Type:
- Woofer : 6.5″ (16.5cm) PP Cone
- Tweeter : 0.8″ (2.0cm) Tetoron Dome
- Maximum RMS Power : 50W
- Maximum Peak Power : 200W
- Impedance : 4ohms (DCR3.6ohms)
- Sensitivity : 92dB SPL (1W @ 1m)
- Frequency Response : 65Hz-20KHz
- Mounting Depth/Droyal-in Mounting : 2-1/2″(6.3cm)
- Cutout Diameter : 5-3/5″ (14.2cm)circle
- Design and specifications are subject to change without notice
Warning
Th is product contains a high performance tweeter.
If there is a tweeter already installed in your car. then you must disconnect its terminals.
If you leave the original tweeter connected and connect this product in parallel, then a fault may develop in this product, so you are strongly recommended not to do so.
If there is a tweeter already installed in your car. then you must disconnect its terminals.
If you leave the original tweeter connected and connect this product in parallel, then a fault may develop in this product, so you are strongly recommended not to do so.
COMPONENT 2-WAY SPEAKER SYSTEM
Documents / Resources
 |
ALPSALPINE DM-65C-G Component Speaker System [pdf] User Guide DM-65C-G Component Speaker System, DM-65C-G, Component Speaker System, Speaker System, System |
