8036 SIP Multimedia Intercom
QuickStart Guide
There are THREE key steps to getting up and running with your new 8036 SIP Multimedia Intercom
Network Setup
- Set up a SIP account on your server so that the 8036 can receive calls (you may have to enlist your network administrator’s help here).
- Plug your 8036 into your PoE network. After a few seconds, the device’s Welcome screen will display (below).
- Note the IP address displayed and enter this into your PC’s web browser to display the 8036 Control Panel. Login with the default password (“algo”)
1 Apart from the physical installation which is covered separately in the 8036 Install Guide. - Once logged in, go to Settings>SIP and enter your SIP account details including SIP domain, User (Extension), and Authentication password.
Create a User Interface Page
- Go to User Interface>Create Pages
- Create one new button page, then click Add Pages.
Configure User Interface Page
- Scroll down to List Pages and click on Page 1 to expand the settings available.
- Enter the settings as shown in the above image.
- For the Dialing Extension field, enter the extension you would like the 8036 to call when the button is clicked.
- When finished, click Save All Pages, after which the 8036 UI will restart.
- After restarting, the 8036 will display your first User Interface screen.
- Touch the button you created to make your first 8036 phone call.
- Now try experimenting. Add some more pages with different layouts. Try different button actions (e.g. set a Goto action to a Dialer page). Soon you will get a UI that will suit your application.
Algo Communication Products Ltd.
4500 Beedie Street
Burnaby, BC Canada V5J 5L2
www.algosolutions.com
Documents / Resources
![]() | ALGO 8036 SIP Multimedia Intercom [pdf] User Guide 8036 SIP, Multimedia Intercom |