AKAI S950RE RAM Expansion Module
INSTALLATION GUIDE
STEP 1 – FLIP IT OVER
Flip your sampler and remove the bottom RAM cover lid
STEP 2 – INSERT THE PLASTIC THING
If your sampler’s board does not have the small plastic PCB holder, one is included with your RAM module; insert it to the board – just push it softly into the hole
STEP 3 – INSERT THE RAM MODULE
The RAM modules are keyed, they can’t be inserted backwards – just push them into the socket
STEP 4 – FIX IT WITH THE PLASTIC WASHER AND M2.5 NUT
A plastic washer and M2.5 nut is also included with each RAM module; just tighten it with hand, that should be enough
Documents / Resources
 |
AKAI S950RE RAM Expansion Module [pdf] Installation Guide S950RE RAM Expansion Module, S950RE, RAM Expansion Module, Expansion Module, Module |