Airtame AT-CD1PSU APS Power Hub
Specifications
- Power Requirements: PoE+ (46-57V, max 30W) or DC power adapter (12V/55W max)
- Mounting Options: Wall mounting with screws or double-sided tape, flat surface with rubber feet
- HDMI Ports: One active HDMI port, second port disabled
What you need for the setup
- Airtame Hub and the accessories that come with the box.
- Screens that would be used for meetings.
- Camera, Speaker, and Microphone, all with USB outputs.
- A Laptop running Windows, macOS, or Linux.
- RJ45/Ethernet cable for network and/or power. We recommend CAT 5e or higher for PoE+.
- Power delivered must be between 46-57V and a maximum of 30W. o If PoE+ is not available for power, you must purchase a DC power adapter (12 V/55 W max), which can be found here under part number AT-CD1-PSU
- Optional
- 4mm hex key, if you want to lock the device to the wall.
- A screwdriver or a drill, if you want to mount the device’s plate on the wall.
Step 1: Select the location
Make sure all peripheral, power, Ethernet, and screen cables can reach the Airtame hub.
Step 2: Mount the Mounting Plate
The mounting plate can either be connected to a wall using screws or double-sided tape. Alternatively, it can be placed on a flat surface with the 4 rubber feet on the mounting plate.
Screwing the mounting plate
Remove the mounting plate from the Airtame Hub
The mounting plate is held in place with magnets.
- Push down on the end of the Mounting Plate by the label to pivot it and remove it from the Airtame Hub.
Mounting the mounting plate
- Drill holes in the selected location for Wall Plugs.
- Drill holes in the selected location for Wall Plugs.
- Insert Wall Plugs in the holes, and fix the Mounting Plate using the Screws (which can be found in the Accessory Kit).
Sticking the mounting plate using command strips
- Make sure the wall is clean and dust-free.
- Place the included 3M adhesive command strips on the mounting plate.
- Remove the blue foil from the command strips and press the mounting plate against the wall.
Mounting the Airtame Hub on a flat surface
Set the Airtame Hub on a flat surface
Step 3: Connect cables ttothe iriRtameub
- Connect the camera, microphone, and speaker to the USB port.
Connect the HDMI 1.4 port.
- The second HDMI port is disabled at the moment, so make sure to connect to the right HDMI port.
- Connect the Ethernet cable to the PoE+ port to power the Airtame Hub.
- If your network environment does not allow PoE+, you will need to purchase a separate AC power adapter to power your device.
- You can find the Hub AC power adapter for purchase on our accessories page.
Step 4: Place Airtame Hub
- Attach the Airtame Hub to the mounting plate. The magnets will keep it in place.
- Optional: You can lock the Airtame Hub to the Mounting Plate with a 4 mm hex key.
FAQs
Q: Can I use any DC power adapter with the Airtame Hub?
A: No, you must use a DC power adapter with specifications 12V/55W max, part number AT-CD1PSU.
Q: Why is the second HDMI port disabled?
A: The second HDMI port is currently disabled and not in use.
Documents / Resources
 |
Airtame AT-CD1PSU APS Power Hub [pdf] Instruction Manual AT-CD1PSU, AT-CD1PSU APS Power Hub, APS Power Hub, Power Hub |