External Power Supply for Keypad

The External Power Supply (POPE_700663) has been crafted as a an add-on product to POPP Keypad (POPE700045). It is designed to power the  POPP Keypad.

The scope of delivery includes 1 connector of the type: JST ZH 2 (Datasheet) 

Important safety information.

Please read this and other device guides carefully.The failure to follow the recommendations set forth by Aeotec Limited may be dangerous or cause a violation of the law. The manufacturer, importer, distributor, and / or reseller will not be held responsible for any loss or damage resulting from not following any instructions in this guide or in other materials.

Keep product away from open flames and extreme heat. Avoid direct sun light or heat exposure.

Plug the terminal in the connection jack on the backside of the Keypad and then connect red wire with plus pole of your mains connection and the blue one with minus pole. However, at least two batteries must still be inserted in the keypad.

Connection description.

L: Live

N: Neutral

+: 5V red

– : 0V blue

Leave a comment

Your email address will not be published. Required fields are marked *