Introduction
Thank you for choosing the Baseus Bass EP10 NC True Wireless Earbuds. This manual provides essential information to help you set up, operate, and maintain your earbuds for the best audio experience.
What's in the Box
- Baseus Bass EP10 NC Earbuds (L/R)
- Charging Case
- USB-C Charging Cable
- Ear Tips (S, M, L sizes)
- Quick Start Guide
- Safety Instructions

Image: Package contents including earbuds, charging case, ear tips, USB-C cable, and documentation.
Safety Information
Please read all safety instructions before using this product to prevent damage to the product or harm to yourself.
- Do not disassemble, repair, or modify the product.
- Keep the product away from extreme temperatures (hot or cold), direct sunlight, and moisture.
- Avoid dropping or subjecting the product to strong impacts.
- Do not use corrosive cleaners to clean the product.
- Keep out of reach of children and pets.
- Battery safety: Do not expose the battery to excessive heat (e.g., fire, direct sunlight). Do not crush, puncture, or dispose of the battery in fire or water. There is a risk of explosion if the battery is replaced by an incorrect type.
- The power delivered by the charger must be between a minimum of 2.5 Watts and a maximum of 5 Watts to achieve the maximum charging speed.
Setup
1. First Use and Initial Pairing
- Remove Protective Film: For the first use, tear off the protective film from the charging contacts on both earbuds.
- Charge Earbuds: Place the earbuds back into the charging case and close the lid. Ensure the case has power.
- Initiate Pairing: Open the charging case, take out the earbuds, and wear them. The earbuds will automatically enter pairing mode.
- Connect to Device: On your device (smartphone, tablet, etc.), enable Bluetooth and search for
