VGR V-361

Contents

VGR V-361 Professional Blade Shaver and Hair Trimmer

User Instruction Manual

1. Introduction

Thank you for choosing the VGR V-361 Professional Blade Shaver and Hair Trimmer. This versatile grooming tool is designed for efficient and comfortable hair removal and trimming across various body areas. Please read this manual thoroughly before first use to ensure safe operation and optimal performance of your device.

VGR V-361 Professional Blade Shaver with key features

Figure 1: VGR V-361 Professional Blade Shaver highlighting Dual Sided Trimmer, 500mAh Lithium Battery, and IPX6 Waterproof features.

2. Important Safety Information

Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.

  • Warning: Keep the device and its cord out of reach of children under 3 years old.
  • Keep away from children unless supervised by an adult.
  • Do not use this product for purposes other than its intended use.
  • Inspect the product before each use; do not use if damaged.
  • Follow installation and operation guidelines to avoid injury.

3. Package Contents

Please check the package for the following items:

  • VGR V-361 Shaver/Trimmer Unit
  • Adjustable Guide Comb (with length settings)
  • Foil Shaver Head Attachment
  • Cleaning Brush
  • USB Charging Cable
  • User Manual
Contents of VGR V-361 package

Figure 2: All components included in the VGR V-361 package.

4. Setup

4.1. Before First Use

  1. Remove all protective films from the device and its attachments.

4.2. Charging the Device

  1. Connect the provided USB cable to the charging port at the bottom of the device.
  2. Plug the other end of the USB cable into a certified 5V power adapter (not included).
  3. The device will indicate charging status (e.g., via an LED display).
  4. A full charge typically takes 2.5 to 3 hours.
USB charging port

Figure 3: USB charging port located at the base of the VGR V-361.

5. Operating Instructions

5.1. Power On/Off and Mode Selection

  • To turn on the device: Press and hold the power button for 3 seconds.
  • To turn off the device: Press and hold the power button for 3 seconds.
  • To change modes (if applicable): Short press the power button while the device is on.

5.2. Attaching and Detaching Heads

  • To attach a head (trimmer blade or shaver foil): Align the head with the device body and press firmly until it clicks into place.
  • To detach a head: Gently push the head away from the device body, usually by pressing a release button or tab if present.
Dual-sided trimmer blade

Figure 4: Dual-sided trimmer blade for precise trimming.

Foil shaver head

Figure 5: Foil shaver head for a smooth finish.

5.3. Using the Adjustable Guide Comb

  • Attach the adjustable guide comb to the trimmer blade head.
  • Rotate the dial on the guide comb to select your desired cutting length, ranging from 0.5mm to 10mm.
  • Ensure the comb is securely locked at the chosen setting before use.
Adjustable guide comb

Figure 6: Adjustable guide comb with precise length settings.

5.4. Grooming Tips

  • The VGR V-361 supports both wet and dry use. For best results, ensure skin is clean.
  • For trimming, move the device against the direction of hair growth.
  • For shaving with the foil head, hold the device flat against the skin and move in short, gentle strokes.
  • This device is suitable for use on the head, body, and bikini area.

6. Maintenance

6.1. Cleaning

  • After each use, turn off the device and detach the head.
  • Use the provided cleaning brush to remove any hair clippings from the blades and inside the head.
  • As the device is IPX6 waterproof, you can rinse the heads and the device body under running water. Ensure the device is off before rinsing.
  • Allow all parts to air dry completely before reassembling or storing.
IPX6 waterproof feature

Figure 7: VGR V-361 demonstrating its IPX6 waterproof capability, allowing for easy cleaning under water.

6.2. Storage

  • After cleaning and drying, turn off the device.
  • Store the device and its accessories in a dry place, away from direct sunlight and extreme temperatures.
  • Keep away from children.

7. Troubleshooting

  • Device not turning on: Ensure the device is fully charged. Connect it to the charger and wait for a few minutes before attempting to turn it on again.
  • Poor trimming/shaving performance: Clean the blades and heads thoroughly to remove any hair buildup. Ensure the blades are not damaged.
  • Battery not charging: Check if the USB cable is properly connected to both the device and the power adapter. Try using a different 5V power adapter or USB port.
  • Skin irritation: Ensure your skin is clean and dry (or properly lubricated for wet shaving). Do not press too hard against the skin. If irritation persists, discontinue use.

8. Specifications

BrandVGR
ModelV-361
Voltage110V
Blade MaterialStainless Steel
Power TypeMains and Battery Operation
FunctionsWet/Dry Haircut, Fast Charging, Charging Indication
Maximum Cutting Length11 - 20 mm
Minimum Cutting Length1.1 - 2 mm
Length Adjustment MethodChange of Nozzles (Adjustable Comb)
Number of Nozzles5 or more (via adjustable comb)
PurposeFor the Bikini Area, For Body, For the Head
MaterialABS + Stainless Steel
Certification3C, CE, UL, GS, CCC
Motor TypeVibratory, High-speed motor
Working Time (Trimmer)240 minutes
Working Time (Clipper)250 minutes
Charging Time (Trimmer)2.5 Hours
Charging Time (Clipper)3 Hours
Battery Capacity (Trimmer)2000 mAH
Battery Capacity (Clipper)2500 mAH
RPMMax 9000 RPM
Waterproof RatingIPX6

9. User Tips

  • Shaving Closeness: Note that the shaver may not provide a completely
Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.