1. Introduction
Thank you for choosing the VGR V-613 Professional Nose and Ear Hair Trimmer. This device is designed for efficient and comfortable removal of unwanted nose, ear, and facial hair. Please read this manual thoroughly before first use to ensure safe operation and optimal performance. Keep this manual for future reference.
Safety Precautions
- Keep the device out of reach of children.
- Do not disassemble or attempt to repair the device yourself.
- Do not use the trimmer if it is damaged.
- Avoid using the trimmer in extremely hot or cold environments.
- Ensure the charging port is dry before connecting the USB cable.
2. Product Components
The VGR V-613 trimmer comes with the following items:
- 1 x VGR V-613 Nose & Hair Trimmer Body
- 1 x Nose Trimmer Head
- 1 x Hair Trimmer Head
- 1 x Cutting Nozzle (2mm/4mm)
- 1 x Protective Cap
- 1 x USB Charging Cable (Type-C)
- 1 x Cleaning Brush
- 1 x Instruction Manual


3. Setup
3.1 Charging the Trimmer
Before first use, fully charge the trimmer. The device features a USB Type-C charging port for convenience.
- Ensure the trimmer is turned off.
- Locate the charging port at the bottom of the trimmer. It has a waterproof design; rotate to open the cover.
- Insert the Type-C end of the USB charging cable into the trimmer's port.
- Connect the other end of the USB cable to a compatible power source (e.g., computer, laptop, USB charger, power bank).
- The LED indicator light will illuminate during charging. A full charge takes approximately 1.5 hours.
- Once fully charged, disconnect the cable and securely close the charging port cover.

3.2 Attaching and Detaching Trimmer Heads
The VGR V-613 comes with two interchangeable heads: a nose trimmer head and a hair trimmer head.
- To detach a head, twist it counter-clockwise until it unlocks and can be pulled off.
- To attach a head, align the head with the trimmer body and twist clockwise until it locks securely into place.
- For the hair trimmer head, you can attach the 2mm/4mm cutting nozzle by sliding it over the blade until it clicks.
4. Operation
4.1 Power On/Off
Press the power button located on the front of the trimmer to turn it on or off. The LED indicator will light up when the device is active.
4.2 Using the Nose Trimmer Head
The nose trimmer head features a three-dimensional cutting system designed to safely and effectively trim nose and ear hair without pulling.
- Attach the nose trimmer head to the device.
- Turn on the trimmer.
- Gently insert the trimmer tip into your nostril or ear canal. Do not insert too deeply.
- Move the trimmer in a circular motion to trim unwanted hair.
- After use, turn off the trimmer and clean the head.


4.3 Using the Hair Trimmer Head
The hair trimmer head is suitable for trimming eyebrows, sideburns, or other facial hair. Use the included cutting nozzle for desired length.
- Attach the hair trimmer head to the device.
- If desired, slide the 2mm/4mm cutting nozzle over the blade.
- Turn on the trimmer.
- Hold the trimmer against the skin and move it slowly against the direction of hair growth.
- After use, turn off the trimmer and clean the head.

5. Maintenance
5.1 Cleaning the Trimmer
The VGR V-613 is IPX5 waterproof, allowing for easy cleaning.
- Turn off the trimmer and detach the trimmer head.
- Use the included cleaning brush to remove any loose hairs from the blades and inside the head.
- Rinse the detached head and the trimmer body (ensure the charging port cover is closed) directly under running tap water.
- Allow all parts to air dry completely before reassembling or storing.

5.2 Storage
After cleaning and drying, place the protective cap over the trimmer head. Store the trimmer in a cool, dry place, away from direct sunlight and moisture.
6. Troubleshooting
If you encounter any issues with your VGR V-613 trimmer, please refer to the following common problems and solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Trimmer does not turn on. | Battery is low or depleted. | Charge the trimmer for 1.5 hours until the LED indicator shows a full charge. |
| Poor trimming performance or pulling hair. | Blades are clogged with hair or dull. Battery is low. | Clean the trimmer head and blades thoroughly. Ensure the trimmer is fully charged. |
| Trimmer makes unusual noise. | Trimmer head not properly attached. Internal issue. | Ensure the trimmer head is securely locked in place. If the issue persists, contact customer support. |
7. Specifications
Technical details for the VGR V-613 Professional Nose and Ear Hair Trimmer:
| Feature | Specification |
|---|---|
| Model Number | V-613 |
| Brand Name | VGR |
| Power Type | Rechargeable/Electric Both Work |
| Power Supply | USB-Type C |
| Charging Time | 1.5 Hours |
| Working Time | 150 Minutes |
| Battery | 500 mAh Li-ion battery |
| Blade Material | Stainless Steel |
| Product Material | Plastic (ABS) |
| Clean Method | IPX5 Waterproof (Whole body washable) |
| Voltage | Global Universal (100-240V) |
| Input | DC 5V 1A |
| Power | 5W |
| Size | 13 x 2.4 x 2.4 cm |
| Product Weight | 69g |
| Cutting Length | 0-4mm |
| Comb Settings | 2 settings (2mm/4mm) |
| Certification | CE, Dot, EAC, EPA, FCC, GMP, RoHS, TGA, UL, KC, pse, weee |
| Origin | Mainland China |

8. User Tips
- For optimal performance, ensure the device is fully charged before each use.
- Regularly clean the trimmer heads and blades to maintain cutting efficiency and hygiene.
- Always use the protective cap when storing the trimmer to prevent damage to the blades.
- The IPX5 waterproof rating allows for both dry and wet trimming, including use with foam or in the shower.
9. Warranty and Support
The VGR V-613 Professional Nose and Ear Hair Trimmer comes with a 12-month warranty from the date of purchase. This warranty covers manufacturing defects under normal use. It does not cover damage caused by misuse, accidents, unauthorized repairs, or normal wear and tear.
For warranty claims or technical support, please contact the seller or authorized service center with your proof of purchase.





