1. Product Overview
The Jebao TSP 15000 Pump Controller is designed to provide precise control over compatible water pumps, allowing for adjustment of power output and operational modes. This manual provides instructions for the safe and efficient use of your controller.
2. Safety Instructions
- Read all instructions carefully before use.
- Ensure the power supply matches the requirements of the controller and pump.
- Do not immerse the controller in water. It is designed for indoor or protected outdoor use.
- Keep out of reach of children.
- Disconnect power before performing any maintenance or connections.
- Do not operate if the controller or cables are damaged.
3. Setup and Installation
- Unpack: Carefully remove the controller from its packaging and inspect for any damage.
- Identify Connections: The controller typically has two cable glands at the bottom. One is for connecting to the pump, and the other is for connecting to the power supply.
- Connect to Pump: Securely connect the pump's power cable to the designated output port on the controller. Ensure a watertight seal if applicable.
- Connect to Power: Connect the controller's input power cable to a suitable power outlet.
- Placement: Place the controller in a dry, well-ventilated area, away from direct sunlight or extreme temperatures. Ensure it is easily accessible for operation.
4. Operating Instructions
The controller features a digital display and three control buttons:
- Play/Pause Button (|| / >): Toggles the pump operation between running and paused states.
- Down Arrow Button (↓): Decreases the pump's power output or adjusts settings downwards.
- Up Arrow Button (↑): Increases the pump's power output or adjusts settings upwards.
Basic Operation:
- Power On: Once connected to power, the display will illuminate, showing the current power setting or status.
- Start/Pause Pump: Press the Play/Pause button to start or pause the pump. When running, the display will show the current power consumption in WATTS.
- Adjust Power: Use the Up (↑) and Down (↓) arrow buttons to increase or decrease the pump's power output. The display will show the adjusted wattage.
5. Maintenance
- Cleaning: Periodically wipe the controller's exterior with a soft, dry cloth. Do not use harsh chemicals or abrasive cleaners.
- Connections: Regularly check all cable connections to ensure they are secure and free from corrosion or damage.
- Environment: Ensure the operating environment remains within the recommended temperature and humidity ranges to prevent damage.
- Cable Integrity: Inspect power and pump cables for any signs of wear, cuts, or fraying. Replace damaged cables immediately.
6. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Controller display is off. | No power supply. | Check power connection and wall outlet. |
| Pump not running. | Pump paused, incorrect connection, or pump fault. | Press Play/Pause button. Verify pump cable connection. Check pump for issues. |
| Cannot adjust power. | Buttons unresponsive or controller fault. | Ensure pump is running. Try restarting the controller by unplugging and re-plugging. |
7. Specifications
| Feature | Detail |
|---|---|
| Model | TSP 15000 Controller |
| Dimensions (Approx.) | Length: 20 cm, Width: 15 cm, Height: 15 cm |
| Weight (Approx.) | 1.5 kg |
| Origin | Mainland China |
| Power Display | Digital display in WATTS (e.g., TSP-100W variant shown in image) |
8. User Tips
- For optimal performance, ensure the controller is paired with a compatible Jebao TSP series pump.
- Regularly check the pump and controller connections for any signs of wear or loose fittings to prevent operational issues.
- If the controller is exposed to moisture, immediately disconnect power and allow it to dry completely before attempting to use it again.
9. Warranty and Support
For warranty information, technical support, or service inquiries, please contact your original retailer or the manufacturer directly. Keep your purchase receipt as proof of purchase.
