ACR Bivy Mesh Stick Satellite Communicator
Let’s get started!
Get to know your Bivy Stick MESH
Visit support.bivy.com for a detailed user guide on both the Bivy Stick MESH and the Bivy App
Charge your device
Use the supplied USB-C cable
WARNING
Applying a voltage higher than 5V may damage the device.
Power & Charging Indicator Light
Flashing: Device is charging
Solid: Device is powered on
Download the app and setup your profile
Connect to Bluetooth
- Power on the device
On/Off: Press & Hold Power Button 2-Seconds- Bluetooth Pairing Mode: Single press to wake device and activate Bluetooth pairing mode for 3 minutes.
- In the Bivy App, navigate to the STICK tab and connect
Not Connected Connect
Setup Your SOS Profile
Enter Your Emergency Contacts
Your emergency contacts will be notified by the Rescue Center when SOS has been activated.
Critical Warning!
Please create SOS profile now! Setup SOS Profile
Activate Your Bivy Stick MESH
- Press Activate
- Choose a plan and follow the instructions
Account Inactive Activate
SOS
In case of emergency you can activate an SOS using the Bivy app or with the SOS button on the device. It is recommended to use the app to establish 2-Way communication with the Rescue Center. The SOS button is located under the red flap on the bottom of the device.
- Activate: Press and hold for 5 seconds.
- Cancel: Press and hold for 5 seconds.
Once the SOS is activated, the status light will begin to flash red and an emergency message will be sent to the Rescue Center, along with your location, once per minute for 10 minutes, and then every 10 minutes thereafter. It will also flash yellow initially letting you know that a message is queued up to be sent. Once the red light stops flashing, the SOS has been canceled. The Rescue Center will dispatch and manage all the emergency needs and resources necessary. This service is available worldwide.
Signal Lights
WAKE MODE SIGNAL LIGHT ON
Green: Strong Satellite Yellow: Medium Satellite- Red: Weak to no satellite Off: Sleep mode
SLEEP MODE SIGNAL LIGHT OFF Single press power button to wake device for 3-minutes
Note: The Stick listens for incoming messages for 15 minutes after sending one.
It then goes into sleep mode but wakes every 15 minutes to check messages.
Status Lights
- Green: New Message in Mailbox (Connect to the Bivy App to view message).
- Yellow: Sending (Message or Track point).
Note: A persistent flashing yellow light indicates a message is trying to send. Relocate to an open sky view and wait for satellite connection. - Blue: Bivy Stick Tracking Mode
- Active Red: SOS Active
Sending Check-In Messages
The Bivy Stick transmits your preset message, current GPS location, and a map link to your selected contacts.
Checking in. All good. [37.733952, -119.637756] www.bivygate.com/353NJ
- To send a Check-In message, press the Check-In button once.
Note: To personalize this message, use the Bivy app. - The STATUS light will flash YELLOW and stop flashing when the message is sent.
Tracking With the Bivy Stick
Your GPS location is updated at regular intervals on your Bivy Live Tracking Page, which is accessible via a shared unique URL.
- 10 min (1 credit per 1 hour) – Default
- 2 min (1 credit per 12 mins)
- 5 min (1 credit per 30 mins)
- 10 min (1 credit per 1 hour)
- 30 min (1 credit per 3 hours)
- 60 min (1 credit per 6 hours)
- To start tracking, press and hold the
CHECK-IN button for 5-seconds until the STATUS light flashes BLUE. - The STATUS light continuously flashes BLUE while in tracking mode.
Note: Tracking with the Bivy Stick uses the built-in GPS. If tracking is initiated via the app, the map will use the phone’s GPS. - To stop tracking, hold Check-In button for 5 seconds until the STATUS light stops flashing BLUE.
- After you stop tracking, keep the Bivy Stick out in the open, facing the sky. Wait until the yellow STATUS light stops flashing to make sure all your location data is sent.
Mounting System
The Bivy Stick comes ready to adapt to any GoPro® mounting system. This is done by using the provided ¼” – 20, 2-prong GoPro® mount adapter. Thread the adapter into the back of the Bivy Stick, then attach to the GoPro® mounting system of your choice.
WARNING
If attaching to the outside of a vehicle or location that may see high wind speeds, vibrations or force, you should use a secondary tether to ensure you do not lose or damage your Bivy Stick.
GoPro® is a registered trademark of GoPro, Inc. of Delaware, which is not affiliated with the maker of this product and does not endorse this product.
Technical Specs
- Dimensions: 11.4 cm x 4.8 cm x 2.1 cm (4.49” x 1.89” x 0.83”)
- Weight: 3.95 oz / 112 g
- Ingress Protection Rating: IP67
- Battery Type: Lithium Ion Polymer
- Battery Size: 1450 mAh
- Battery Life: Up to 145 hrs standard operation at default setting (Satellite Only)
- Optimal Operating Temperature: –20°C to 40°C
SAFETY AND PRODUCT INFORMATION USAGE REQUIREMENTS
- Messaging, tracking, SOS, weather and all Bivy Stick features require an active Bivy Stick data plan. You will need to pay for a plan of service in order for your Bivy Stick to communicate with the satellite network. Always test your device before taking it off grid.
- Ensure that you have clear view of the sky when using messaging, tracking
and SOS. - Battery Warning and Notices: A lithium-ion polymer battery is used in this device. The battery is internal and non-user-replaceable for various purposes. If these guidelines are not followed, batteries may experience a shortened life span or may present a risk of damage to the device, fire, chemical burn, electrolyte leak, and/or injury. Also, failure to heed the following notice could result in personal or property damage, or negatively impact the device functionality.
- Do not disassemble, modify, re-manufacture, puncture or damage device or battery.
- Do not remove or attempt to remove any components of the device.
- Do not expose device to fire, explosions, high temperatures or other hazards.
- Do not place in high temperature environments. Such as an unattended vehicle, near a heater, or fire, or in direct sunlight for extended periods of time.
- Do not submerge or soak device in any liquid.
- Do not operate device outside of the recommended temperature ranges.
- When storing the device for extended periods of time, store in a dry environment in temperatures between 35F and 75F.
- Do not use a power/data cable that is not approved or supplied by Bivy.
- Do not place device on dashboard or any other unsecured place in vehicle. Also be sure that it is not located someplace that will be a distraction while operating a vehicle. In the case of accident or crash, an unsecured device could injure driver or passenger.
- Do not use the Bivy Stick MESH or Bivy app while driving. Always stop and park vehicle before using cell phone or app.
- Bivy uses maps provided by public and private sources and is not responsible for the accuracy of the map. Some data may be inaccurate and incomplete.
- By using the device you agree to the terms and conditions of the user agreement. To review those terms please visit: https://www.bivy.com/terms
- By using the device you also agree to the terms and conditions of the privacy policy. To review those please visit: https://www.bivy.com/privacy
- If disposing of the device, please do so in accordance with local regulations according to Lithium Ion Polymer battery disposal.
- The Bivy Stick MESH is a mobile transmitter and receiver that uses an internal antenna to send and receive low levels of radio frequency energy for data communications. The device emits RF energy below the published limits when operating in its maximum output power mode. To comply with RF exposure compliance requirements, the device should be a minimum of 20cm between the device and your body during operation. The device should not be used in other configurations. This device must not be co-located or operated in conjunction with any other transmitter or antenna.
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl) phthalate (DEHP), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
WARRANTY
Available at www.bivy.com/warranty. Or request via mail or phone:
- ACR Electronics, Inc., 5757 Ravenswood Road, Fort Lauderdale, FL 33312, USA. +1.954.981.3333
DECLARATION OF CONFORMITY
Hereby, ACR Bivy declares that this product is in compliance with the Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: www.acrartex.com
UK DECLARATION OF CONFORMITY
Hereby, ACR Bivy declares that this product is in compliance with the relevant statutory requirements. The full text of the declaration of conformity is available at the following Internet address: www.acrartex.com
RADIO FREQUENCY RADIATION EXPOSURE
This device is a portable transmitter and receiver that uses an internal antenna to send and receive low levels of radio frequency (RF) energy for data communications. The device emits RF energy below the published limits for portable use when operating in its maximum output power mode and when used with ACR Bivy authorized accessories. To comply with RF exposure compliance requirements, the device should be used as described in the manual. The device should not be used in other configurations.
FCC INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and may cause harmful interference to radio communications if not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult dealer or an experienced radio/TV technician for help.
This device does not contain any user-serviceable parts. Repairs should only be made by Bivy or an ACR authorized service center. Unauthorized repairs or modifications could result in permanent damage to the device, and void your warranty and your authority to operate this device under part 15 regulations. Bivy is an ACR company.
INNOVATION, SCIENCE AND ECONOMIC DEVELOPMENT CANADA COMPLIANCE This device contains license-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
AUSTRALIAN AND NEW ZEALAND PURCHASED GOODS
ACR Bivy goods and services come with guarantees that cannot be excluded under the Australian Consumer Law and similar legislation in New Zealand. For major failures with the service, you are entitled:
- to cancel your service contract with us; and
- to a refund for the unused portion, or to compensation for its reduced value. You are also entitled to choose a refund or replacement for major failures with goods. If a failure with the goods or service does not amount to a major failure, you are entitled to have the failure rectified in a reasonable time. If this is not done, you are entitled to a refund for the goods and to cancel the contract for the service and obtain a refund of any unused portion. You are also entitled to be compensated for any other reasonably foreseeable loss or damage from a failure in the goods or service.
ACR Electronics, Inc., 5757 Ravenswood Road, Fort Lauderdale, FL 33312, USA. +1.954.981.3333
Customer Support
Have Questions? Visit support.bivy.com for how-to videos, user guides, FAQs, and more.
Customer Service Hours
- Monday – Friday, 6:00 AM – 9:00 PM MST
- support@bivy.com
- +1 385-955-0998 (Call or Text)
- support.bivy.com
MADE IN USA
FCC ID: B66-ACRBV3
IC: 1322A-ACRBV3 MADE IN USA
FAQ
- Q: How do I activate an SOS on the Bivy Stick MESH?
A: In case of emergency, you can activate an SOS using the Bivy app or with the SOS button on the device. It is recommended to use the app for 2-way communication with the Rescue Center. Press and hold the SOS button for 5 seconds to activate. - Q: What do the signal status lights indicate?
A: Green indicates a strong satellite signal, yellow indicates a medium signal, red indicates weak to no satellite signal, and off signifies sleep mode.
Documents / Resources
 |
ACR Bivy Mesh Stick Satellite Communicator [pdf] User Guide Bivy, Bivy Mesh Stick Satellite Communicator, Mesh Stick Satellite Communicator, Stick Satellite Communicator, Satellite Communicator |