PHILIPS 8719514954632 ProjectLine LED Floodlight

Specifications

• IP Ratings: IP20, IPX3, IPX4, IPX5, IPX6, IPX7, IPX8
• Cable Length: 2.25m
• Maximum Cable Extension: 3m
• Country of Origin: Netherlands
• Last Update: 09/12/15

Product Usage Instructions

Safety Instructions
Ensure proper distance between the lamp and the lighted object.
Follow the IP ratings for water protection.

IP Ratings Explanation

• IP20: No special protection against water.
• IPX3: Protection against raindrops.
• IPX4: Protection against splashing water.
• IPX5: Protection against water jets.
• IPX6: Protection against powerful water jets.
• IPX7: Protection against temporary immersion in water.
• IPX8: Protection against continuous immersion in water.

Protection Classes

• Protection Class I: Earth connection required.
• Protection Class II: Double or reinforced insulation.
• Protection Class III: Suitable for safety extra low voltage supply.

FAQ

What is the maximum cable extension?
The maximum cable extension is 3m.

SAFETY INSTRUCTIONS – PART B

This manual B contains definitions of all potentially applicable parameters & specifications with icons, as per International norms and safety standards. However not all of them may be applicable for the product you purchased – please refer to the icons on the additional Manual A, for the ones which are particulary applicablem for this product.

• To ensure correct and safe installation, usage and functioning of the product, always follow these instructions carefully and keep them for future reference.
• Always switch off the power prior to installation, maintenance or repair activities. Always consult a professional in advance, for choosing the right fastener for a secure mounting of the product. Take into account the weight of the product and the material of the mounting surface.
• If in doubt, consult a qualified or licensed electrician or contact your retail outlet. Ensure the product is always installed according to relevant regulations. Certain regulations indicate that electrical products must be installed only by a licensed electrician (e.g. Part P for the UK, AS/NZS3000 IN for AUSTRALIA /NEW ZEALAND).
• Always tighten the terminal screws firmly, especially attachments for low voltage wiring (12V) (if applicable). It is highly recommended to regularly check and re-tighten the terminal screws over time.• Observe the correct colour of the wiring before installation: blue (N), brown (L) and if protection class I, yellow/green (earth).
• Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents. Avoid liquids on all electrical parts.
• Mount wall lights out of children’s reach.
• If the product is mounted on a metallic surface, this surface must be bonded to the protective earth conductor or to the equipotential bonding conductor of the installation.
• Always consider all technical specifications of the product. Verify stated icons on the identification label on the product and icons shown in part A of these safety instructions.
• Immediately replace a cracked or broken translucent cover and only use manufacturer approved parts.
• It is advised to only use “Philips”-branded bulbs.
• Keep packaging materials out of children’s reach. (e.g. plastic bags,…)
• Disposal of the product. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2012/19/EU. Please inform yourself about the local waste disposal, separation and collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old product with your normal household waste. The correct disposal of your product will help prevent potential negative consequences for the environment and human health.

ATTENTION: Below you will find all the explanations with numeric reference to the icons respectively in front of these safety instructions:

1. The product should only be installed indoors.
2.  The product is not suitable for installation in bathrooms, certainly not in the specified zone.
3.  The product is suitable for mounting on normally flammable surfaces.
4. The product is not suitable for direct mounting on normally flammable surfaces.
5. The product is not suitable for covering with thermally insulating material.
6.  The product is only suitable for mounting on the ceiling.
7. The product is only suitable for mounting on the wall.
8. The product is suitable for mounting on the wall or on the ceiling.
9. Always take into consideration the minimum distance, as indicated on the icon,] between the lamp and the lighted object.
10. IPX1: The product is protected against dripping water.
11. IPX3: The product may be exposed to raindrops (falling drops under a maximum angle of 60° to the vertical axis).
12. IPX4: The product is splash-proof: it may be exposed to splashing water coming from any direction (360°).
13. IPX5: The product is protected against water jets.
14. IPX7: The product can be installed into the ground.
15. IPX8: The product is protected against immersion up to the indicated depth.
16. IP5X: The product is dust protected.
17. IP6X: The product is dust tight.
18. Immediately replace a cracked or broken safety glass and only use borosilicate parts of the same dimensions, with a minimum thickness of 3 mm.
19. Protection class I: the product or component has an earthing connection. The earth wire (yellow/green) has to be connected to the terminal marked with .
20. Protection class II: the product or component is provided with double or reinforced insulation.
21. Protection class III: the product or component is only suitable for safety extra low voltage supply (<50Va.c.; <120Vd.c.)
22. Strip the wire as indicated on the icon.
23. The earthing wire always has to be longer than the brown live (L) and blue neutral (N) wire.
24. The use of the supplied heat-resistant sleeving is required over the unstripped wire lengths.
25. The product is only suitable for wiring directly to the electrical mains supply.
26. X-connection: In case of damage to the wire, it has to be replaced by a wire of the same type.
    • Y-connection: In case of damage to the wire, it has to be replaced only by the manufacturer, distributor or by an expert, to avoid risks.
    • Z-connection: The external flexible cable or cord of this luminaire cannot be replaced.
    • If the cord is damaged, the luminaire shall be destroyed.
27. MAX. …W: only use bulbs suitable for this product and keep within the maximum specified wattage.
28. The product is only suitable for reflector bulbs.
29. The product is only suitable for CFL-i – or LED-bulbs ( e.g. E14, E27, Gu10, Gx53, …)
30. The product is not suitable for CFL-i – or LED-bulbs ( e.g. E14, E27, Gu10, Gx53, …)
31. Only a bulb with a diameter of 60 mm can be used. A bulb with a 45 mm diameter must not be used for this product.
32. Only use a globe bulb that has the size of the indicated diameter. Never use a standard incandescent bulb.
33. This product is only suitable for candle shaped bulbs.
34. The product is only suitable for a bulb with built-in safety or a low pressure bulb. An extra safety glass is not necessary.
35. Capsule and linear halogen bulbs may not be touched by bare hands.
    
36. The product is equipped with a fuse. If the product is out of order after bulb replacement, the internal fuse has to be replaced.This must be done by a qualified electrician if contact with internal wiring can be made.
37. product is dimmable with the supplied dimmer or with a (not included) dimmer connected to the electrical installation of the home. For reference please visit “www.philips.com“. Consult a qualified electrician for choosing the suitable dimmer type.
38. The product is not dimmable.
39. The product is dimmable with the supplied dimmer ONLY. Do not connect to an additional dimmer.
40. The product is working with a safety transformer. Replace a broken transformer only with a transformer with identical technical specifications. Consult a qualified electrician or your retail outlet.
41. Product for rough service.
42. Product with time and light setting options. Minimum and maximum is indicated on the icon.
43. The product can be mounted up to a maximum height of 6 m.
44. For reliable operation, you have to mount the product on the specified height as indicated on the icon. The maximum and minimum reach of the detector is also indicated.
45. The standard active range of vision of the detector covers the given degrees indicated on the icon.
46. This product should be mounted horizontally. For longer life, the bulb should not be at an angle greater than 4 degrees.
47. Ensure not to drill through electrical wires or any other obstruction in the wall or ceiling during installation!
48. If the product is mounted onto a ceiling-box or wall-box, it is obliged to cover the box with a lid first. (e.g. The Netherlands)
49. Electrical wiring may never be clamped or twisted between the product and the mounting surface!
50. Parts of this product may get hot.
51. This product is not suitable for children under Y years.
52. The product is only suitable for persons above Y years.
53. Mount the product out of arm reach (X1: for children, X2: for adults).
54. The product is only settable during installation by means of a tool.
55. Caution: Risk of electric shock! The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
56. The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
57. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.

The product – as well as all other products from the collection – is designed, produced and tested in accordance with international/European safety standards (e.g. IEC/EN60598 ;.
We warrant that the product is free from defects in materials and workmanship. This warranty is valid for two (2) years (unless otherwise stated on the packaging). In case the product turns out to be defective, we will arrange for repair or replacement free of charge. Broken glass, batteries and replaceable bulbs do not fall under the guarantee terms. The product is specifically designed and developed for domestic use only, not for commercial, trade or industrial use. Any damage caused to the product in extreme conditions (coastal areas, industrial surroundings, farm environments)  will not be covered by the guarantee. The period of guarantee starts from the purchase date and is only valid on presentation of the original receipt. The guarantee is void if the product has not been installed, repaired or modified according to the instructions. We do not accept any liability for damage caused as a result of misuse or wrong application of the product. To obtain service within the warranty period, please contact your dealer or the Philips Consumer Care center. The contact details can be found on: “www.philips.com” or you can call the toll-free number 00800 744 547 n75. Alterations in design and technical specifications reserved.

Documents / Resources

PHILIPS 8719514954632 ProjectLine LED Floodlight [pdf] Instruction Manual 8719514954632 Project Line LED Floodlight, 8719514954632, Project Line LED Floodlight, Line LED Floodlight, LED Floodlight, Floodlight

References

• User Manual