GARMIN CS500 Geiling Fan with Light User Manual
Customer Service: support@breezary.com
Safety Information
READ AND SAVE THESE INSTRUCTIONS.
- To reduce the risk of electric shock, ensure electricity has been turned off at the circuit breaker or fuse box
before you begin. - All wiring must be in accordance with the National Electrical Code “ANSI/NFPA 70” and local electrical codes. Electrical installation should be performed by a qualified licensed electrician.
- The outlet box and support structure must be securely mounted and capable of reliably supporting a minimum of 35 lbs (15.9 kg). Use only UL Listed outlet boxes marked “ Acceptable for Fan Support of 35 lbs. (15.9 kg) or less. ”
- Do not place objects in the path of the blades.
- To clean the fixture, turn off the power, wait for it to cool, and wipe the fixture with a clean, soft cloth.
- After making electrical connections, spliced conductors should be turned upward and pushed carefully up into the outlet box. The wires should be spread apart with the grounded conductor and the equipment grounding conductor on one side of the outlet box and ungrounded conductor on the other side of the
outlet box. - All setscrews must be checked and retightened where necessary before installation.
Dimension Reference
Hardware Included
Fan Parts Included
Installation Instructions
STEP.1 INSTALLATION WALL STOPPER
Caution: Turn off all switches and make sure there is no power when installing .
If it is a cement roof, four holes need to be drilled according to the position of the holes on the installation plate, and then inserted into the wall plug. If it’s a wooden roof, it doesn’t need to be.
STEP.2 INSTALLATION PLATE
– Thread the power cord through the holes on the installation plate and lock it at the top with four wooden screws.
– Remove two symmetrical screws from the installation plate.
STEP.3 INSTALLATION MOTOR ASSEMBLY
– Hang the safety rope of the fan onto the hook on the installation plate.
– Connect the green ground wire to the ground wire. Connect the white wire to the zero wire. Connect the black wire to the fire wire.
– Clip the keyhole on the fan connection plate into the two screws on the installation plate. Then tighten the four screws.
Remote control instruction
-Please pair the remote with the fan before using it.
– Open the battery cover on the hand-held remote and install a battery, pair of AAA emitter (1.5V) that are not included.
– Open the battery cover on the hand-held remote and install a battery, pair of AAA emitter (1.5V) that are not included.
Remote control pairing code:
Turn on the power, and press the pairing code button .
. within 5 seconds. When you hear a “beep” sound or the light flashes, the code pairing is successful. If you need to match the code again, wait 30 seconds and repeat the above operations
Turn on the power, and press the pairing code button .
. within 5 seconds. When you hear a “beep” sound or the light flashes, the code pairing is successful. If you need to match the code again, wait 30 seconds and repeat the above operationsTroubleshooting Guide
If you have in difficulty operating your new ceiling fan it may be the result of incorrect assembly, installation, or
wiring. In some cases these installation errors may be mistaken for defects. If you experience any faults please check this troubleshooting guide.
wiring. In some cases these installation errors may be mistaken for defects. If you experience any faults please check this troubleshooting guide.
Contents
hide
Documents / Resources
 |
GARMIN CS500 Geiling Fan with Light [pdf] User Manual CS500 Geiling Fan with Light, CS500, Geiling Fan with Light, Fan with Light, Light |