jONSBO C6 PC Case

Package Content
Connectors
Parts Diagram
Parts
- Top Mesh Panel
- Right Mesh Panel
- Left Mesh Panel
- Front Mesh Panel
- PCI slot Cover
- PCI slot bracket
- Main Chassis
PSU installation
- Press the button on the rear panel of the chassis to open the top panel.
- push the side panel and front panel out of the inside of the case.
Before installation, please also remove all
- Remove the multi-functional brackets
Motherboard Installation
Insert the MB diagonally through the front case into the case, secure with screws
Motherboard Installation
- Remove PCI slot cover, and PCI slot brackets
- Insert the graphics card to MB slot, secure with screw
Fan bracket installation
- Install the fan brackets to the fan
- Insert the fan assembly into the chassis, and secure.
Storage device installation
2.5″ SSD or 3.5″ HDD install on the multi-functional brackets, and than mount on the corresponding mounting points
PSU installation
- Connect all the cables before mounting the PSU into the case
- Put the PSU on the mounting area and fix it with screws
Mesh panel installation
- Install the mesh panels
2022 JONSBO Technology Co., Ltd. All right reserved. Specifications are subject to change without prior notice. Some trademark may be claimed as the property of others.
Documents / Resources
![]() | C6 PC Case |
References
- User Manualmanual.tools


How do you connect the fan to the base of the frame?
How do I install a fan at the bottom of the JONSBO C6 case?
To install a fan at the base (bottom) of the JONSBO C6 frame, follow these steps based on the Fan Bracket Installation section of the manual:
The case supports either 120mm or 140mm fans at the bottom. Note that you may need to remove the multi-functional brackets first if they are currently installed in that area.
Read the full Q&A page