ZONITH A5 Bluetooth Beacon Instructions

ZONITH A5 Bluetooth Beacon

DECLARATION OF CONFORMITY

FCC ID: 2AJ8P-ZONITHA5
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Information

The device has been evaluated to meet general RF exposure requirement.
The device can be used in Omm exposure condition, compliance with exposure requirements.
Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.

ABOUT ZΟΝΙΤΗ

ZONITH A/S is a Scandinavian manufacturer of advanced solutions for the protection of people. More info at www.zonith.com

COPYRIGHT AND TRADEMARK INFO

© 2025 ZONITH A/S. ZONITH, the ZOΝΙΤΗ logo and “ZONITH A5” are trademarks of ZONITH A/S. All rights reserved.

CUSTOMER SUPPORT

Model No.: ZONITH A5
Made in China FCC ID: 2AJ8P-ZONITHA5
CE, RoHS Ready

GET DATASHEET:

Or go to www.zonith.com/downloads