Zihatec Rev A ArduiBox Feather Din Rail Cap Rail Mount Instruction Manual
| Rev. | Date | Description |
| A | 2023-10-10 | First Release |
Tools
a regulated soldering iron (25..40W) with small tip
a wet sponge to clean the tip
thin solder wire
Side cutting pliers
Needle nose pliers
Medium cross slot screwdriver
Parts
1x 2pole terminal block |
2x 3pole terminal block |
1x 12pole centipede header |
1x 16pole centipede header |
1x 12pole female header |
1x 16pole female header |
1x 2x5pole female header |
2x self-tapping screws |
Place and solder the female headers
Please assemble and solder the both female headers as in the picture below:
Place and solder the centipede headers
Please assemble and solder the 2 centipede headers as in the picture below:
Place and solder female header K4
Please assemble and solder the 2×5 female header as in the picture below:
Preparing of 3pole terminal blocks
Find the terminal blocks, they’re grey or blue and come in 3-pin shape. We’ll need to slide two 3-pin blocks together:
Place and solder the terminal blocks
We’ve to put the blocks into the proto plate. Make sure you place them so that the open ends are facing out as shown:
Test the voltage regulator
You have to measure a voltage between 4.9 – 5.1V between GND and 5V pad!
Mount the pcb into the bottom shell
Fix the pcb in the lower shell with the screws
Mount the Feather boards
It’s time to mount the Feather board and optional wing and/or Ethernet module:
Mount the top shell
Finish!
Documents / Resources
 |
Zihatec Rev A ArduiBox Feather Din Rail Cap Rail Mount [pdf] Instruction Manual Rev A ArduiBox Feather Din Rail Cap Rail Mount, Rev A, ArduiBox Feather Din Rail Cap Rail Mount, Feather Din Rail Cap Rail Mount, Rail Cap Rail Mount, Cap Rail Mount, Rail Mount |
