Zigbee ZG-005 Three Mode Switch Instruction Manual

Zig bee
Three Mode Switch
Model: 2G-005
Model: 2G- 005-RF

Parameters:

Input voltage: AC 85V~250V 50/60Hz
Max. Current: 2200W/10A/gang
Wireless Standard: Zigbee
Working temperature: -20°C~70°C
Size: 69*41*20mm
Checklist before using the device

• You need to have a Zigbee gateway.
• Try to be close to the Zigbee gateway when pairing.

Add device flow to mobile APP

Here is an example of adding a device to tuya Zigbee gateway

1. After installation, power on the device and confirm that the device’s network indicator is flashing Status, click the Zigbee gateway card. (If the device network indicator is not flashing, you can press and hold any manual Switch for 8 seconds to reset the device)
   
2. Click “Add sub device”.
   
3. Wait for about 1 minute until the device is found, then click “Done” .
   
4. Add successfully, return to the main interface of tuya, you can see the newly added device.
5. When the device’s network indicator light is on, remote control can be performed.

APP Function

Remote control matches the code

Matching:

1. hold the manual switch for 3 seconds until RF pairing indicator(blue light)is on.
2. then long press the remote control buttons.
3. loosen the remote control buttons, matching success.

Clear code:
Long press the manual switch for 15 seconds (RF pairing indicator is always on), loosen the manual swith until RF pairing indicator is off.
* note: the matching/clear code method is only available with RF function switch/module reference.

TROUBLESHOOTING

Solutions for the failure of product matching and offine:
Enter the homepage of App, click the icon in the lower right corner of the interface to enter.