INSTRUCTION MANUAL
Zigbee Switch Module-L
1CH,2CH,3CH,4CH
（No Neutral Wire Required）
1CH Switch Module-L
TECHNICAL SPECIFICATIONS
| Product type | Zigbee Switch Module-L |
| Voltage | AC200-240V 50/60Hz |
| Max. load | 1CH: 10-100W 2CH: 2x (10-100W) 3CH: 3x (10-100W) 4CH: 4x (10-100W) |
| Operation frequency | 2.405GHz-2.480GHz |
| Operation temp. | -10℃ + 40℃ |
| Protocol | IEEE802.15.4 |
| Operation range | <100m |
| Dims (WxDxH) | 39.2×39.2×18 mm |
| IP rating | IP20 |
| Warranty | 2years |
| Certificates | CE ROHS |
with a mounting clip
INSTALLATION
Warnings:
- Installation must be carried out by a qualified electrician in accordance with local regulations.
- Keep the device out of reach of children.
- Keep the device away from water, damp or hot environments.
- Install the device away from strong signal sources such as microwave ovens that may cause signal interruption, resulting to abnormal operation of the device.
- Obstruction by a concrete wall or metallic materials may reduce the effective operation range of the device and should be avoided.
- Do NOT attempt to disassemble, repair, or modify the device.
FAQ
Q1: What should I do if I can’t configure the switch module? Q2: What device can be connected to this Zigbee switch module? Q3: What happens if the WIFI goes off? Q4: What should I do if I change the WIFI network or change the password? Q5: How do I reset the device?
Wiring Instructions and Diagrams
- Turn off the power supply before carrying out any electrical installation work.
- Connect wires according to the wiring diagram.
- Insert the module into the junction box.
Turn on the power supply and follow the switch module configuration instructions. - Flash after the lights are off. Please attach accessories.
Warnings: Do not connect the neutral line; otherwise, it will be permanently damaged.
1CH Zigbee Switch Module-L
2CH Zigbee Switch Module-L
Wiring diagram of fittings(L1 L2 One of them)
3CH Zigbee Switch Module-L
Wiring diagram of fittings (L1 L2 L3 One of them)
4CH Zigbee Switch Module-L
APP USER MANUAL
http://smart.tuya.com/download
IOS APP / Android APP
Scan the QR code to download the Tuya Smart App, or you can also search the keyword “Tuya Smart” on App Store or Google Play to download the App.
Log in or register your account with your mobile number or e-mail address. Type in the verification code sent to your mobile or email, then set your login password. Click “Create Family” to enter the APP.
Open the control panel of the ZigBee gateway on the App
Before making the reset operation, pls make sure the Zigbee Gateway is added and installed to the WIFI network. Ensure that the product is within the range of the Zigbee Gateway Network.
After the wiring of the switch module is done, press the reset key for about 10 seconds or turn on/off the traditional switch 5 times until the indicator light inside the module is flashing quickly for pairing.
Click “+” (Add sub-device) to select the suitable product gateway and follow the on-screen instructions for pairing.
The connection will take about 10-120 seconds to complete, depending on your network conditions.
Finally, you can control the device via your mobile phone.
SYSTEM REQUIREMENTS
WIFI® Router
ZigBee gateway
iPhone, iPad (iOS 7.0 or higher)
Android 4.0 or higher
Documents / Resources
 | 1CH Switch Module-L |
References
- User Manualmanual.tools