Zhongshan 2BK5L-3407 Remote Controller User Guide

Zhongshan 2BK5L-3407 Remote Controller User Guide

Contents hide

1 Remote controller

2 FCC Statement

3 Documents / Resources

3.1 References

4 Related Posts

Remote controller

Install two 1.5 volt batteries (type AAA, not included) into the remote controller.

Remote controller can be used for on/off, CCT(correlated color temperature), dimming functionality.
This lamp has a memory function: the lamp will maintain the last light mode when it is turned on again.

Note:

Make sure that foot switch is on when using remote controller.

If the remote controller can’t communicate with the fixture, please operate as below step:
a. Turn on the light by using foot switch;
b. Unplug the adapter, press and hold the off button of the remote controller until plug the adapter into the outlet again and the light turn on then off.

Caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates. uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.