ZHEJIANG PE 5200 Series Button Transmitter

Product introduction

Technical data

Maximum channel latch

Release the maximum channel latch

Battery replacement

Warning

1. Keep the transmitter away from moisture and impact to extend the service life.
2. If it is found that transmitter needs to be closely controlled or the button is not too sensitive and the indicator light blinks and darkens,the battery needs to be replaced.
3. Press any button for more than 10 seconds, the transmitter will stop sending wireless signals.
4. Please dispose of used batteries properly.
5. The 00 channel can control all channels,and the code matching function cannot be realized when using this channel.

FCC STATEMENT

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Manufacturer Company Name: Zhejiang General Light Curtain Co.,LTD.
Manufacturer Company Address: Xin Tang Tou Village, Xin Jie Town, Xiao Shan District, Hang Zhou City, Zhe Jiang Province, China

Documents / Resources

	ZHEJIANG PE 5200 Series Button Transmitter [pdf] Instructions PE 5200 Series, PE 5200 Series Button Transmitter, Button Transmitter, Transmitter
	Zhejiang PE 5200 Series Button Transmitter [pdf] Instructions PE 5200 Series Button Transmitter, PE 5200 Series, Button Transmitter, Transmitter

References

• User Manual