ZERO ZERO ROBOTICS V202007 V-Copter Falcon
OVERVIEW
* For more information, please download the User Manual from the official website.
This guide is subject to change without prior notice. Please visit the official website for more detailed information
* According to changes in market demand or production plan. Shenzhen Zero Zero Infinity Technology Co .. Ltd. may change the product specifications and appearance. Please contact us if you have any questions.
Download the V-Coptr App
Download the V-Coptr App from the App Store/Google Play Store.
The V-Coptr App is compatible with iOS 10.0 (or above) or Android 6.0 {or above)
- Charging
Charge the Intelligent Battery
Please charge the intelligent battery to activate it for first time use.
- Charge the Blastoff Controller
Plug the charging cable into the USB-C Port. It takes about 2.5 hours to fully charge. - Check the battery level
Press the power button of Intelligent Battery/ Blastoff Controller briefly. and the battery level indicator light will show the current battery level.
Prepare the Drone
- Install the Intelligent Battery
- Remove the Gimbal Protector and pull out the propellers .
- Press and hold the arm buttons until the arms are completely unfolded.
- Rotate the motors, and unfold all the propeller blades.
- Press and hold the power button for 2 seconds until the status indicator light blinks. Once it’s finished booting up. you will hear a sound.
Prepare the BlastOff Controller
- Unfold the Mobile Device Stand and the Antennas.
- Install the Control Sticks.
- Place your mobile device on the Mobile Device Stand. Use the clamps to secure smaller devices.
- Use the cable of your mobile device (not included in the package) to connect the Blastoff Controller and your mobile device.
- Press and hold the power button for 2 seconds. The Blastoff Controller will beep when it is successfully turned on.
Connect the Drone
- Open the V-Coptr App.
- Press the Link Button on the drone. The Status Indicator Light of the drone will flash green and begin the linking process.
- Start Connecting
Method One: Connect BlastOff Controller and the drone via App
- Method Two: Connect the Blastoff Controller and the drone with the combination keys
- Press and hold the two Custom Buttons+ Record Button for two seconds, the Status Indicator Light of the Blastoff Controller will flash green as it starts to connect to the drone.
- The connection is successful when the Status Indicator Light of the Blast Off Controller is solid green.
- During the connection process. please keep the Blastoff Controller and the drone within 1 meter of each other
Controlling the Drone
The default control mode is shown below. You can choose other control modes in the app.
*Install and Remove the Landing Cear
- Install the Landing Gear
( Attention: Remove the intelligent battery from the drone first.)
- Remove the Landing Gear
( Attention: Remove the intelligent battery from the drone first.}
Flight Safety
Attention:
Improper Flying Environments:
Please check the Disclaimer and Safety Instructions for more details at zerozerorobotics.com/support/downloads.
Please read it carefully before flying.
Documents / Resources
 |
ZERO ZERO ROBOTICS V202007 V-Copter Falcon [pdf] Instructions ZV101, 2AIDW-ZV101, 2AIDWZV101, V202007, V-Copter Falcon, V202007 V-Copter Falcon, Falcon |
