Yunbaoit VT08 Pro Digital Rechargeable Visual Timer

USING INSTRUCTIONS

1. Alarm Mode: 
2. Low Battery Reminder:
   This icon indicates low power and requires to replacement of the batteries.
3. Dial Plate Screen
4. Red Dial
5. Sound Hole
6. Charging indicator light
7. Magnet
8. Charging port
9. Switch
10. Dust plug
11. Alarm Mode Button
12. Setting Scroll Wheel
13. Start/Stop Button

Hibernation and shutdown

1. When the timer is not working, it will automatically enter into hibernation after 30 seconds.
   For frequent use, no need to shut down;
2. When it is not in use for a long time, turn the switch 9 to the left to shut it down.

Countdown Setting

1. Tum switch 9 to the right to turn on the timer
2. Scroll 12 to set the desired time. scroll it clockwise to increase or anticlockwise to decrease the set time,the minimum setting unit is 1 minute.
3. Press 13 ST/SP to start the countdown or pause the countdown during the process.
4. Press the “VOICE” button U to switch the alarm mode in mute, low volume, and high volume.
5. After the countdown ends, the bell will ring, press any key to stop the alarm. Or it stops ringing automatically after 40 seconds.
6. The timer has a memory function, when the countdown is over, it will return to the timing time you set last time by default.

Countup Setting

1. Scroll 12 to set it to “00 00”.
2. Press 13 to start the count.
3. During the timing process, press the ST/SP button 10 to pause and start the timing.
4. When the timer reaches 60 minutes, the bell will ring.

Charge

When the low battery reminder symbol ® appears, please charge the timer with a DC 5V charger.
The charging indicator light 6 turns red when it is charging, and it turns green when fully charged.

Documents / Resources

Yunbaoit VT08 Pro Digital Rechargeable Visual Timer [pdf] User Manual VT08 Pro Digital Rechargeable Visual Timer, VT08 Pro, Digital Rechargeable Visual Timer, Rechargeable Visual Timer, Visual Timer

References

• User Manual