YHK10 Keypad Access Control
Product Information
Specifications:
- Model: XYZ-2000
- Dimensions: 10 x 5 x 3 inches
- Weight: 2.5 lbs
- Power: 120V, 60Hz
- Capacity: 1 liter
Product Usage Instructions:
1. Setup:
Place the product on a flat, stable surface near a power outlet.
Ensure the power cord can reach the outlet comfortably.
2. Filling the Tank:
Open the tank lid and fill it with water up to the maximum
capacity mark indicated inside the tank.
3. Power On:
Plug the power cord into the outlet and press the power button
to turn on the product.
4. Selecting Mode:
Use the mode selection button to choose the desired operating
mode (e.g., low, medium, high).
5. Maintenance:
Regularly clean the tank and filters as per the user manual
instructions to ensure optimal performance.
Frequently Asked Questions (FAQ):
Q: Can I use essential oils with this product?
A: No, it is recommended to only use water in the tank to
prevent damage to the product.
Q: How often should I clean the product?
A: It is recommended to clean the product at least once a week
to maintain its efficiency.
Q: What should I do if the product stops working suddenly?
A: Check the power source and ensure proper maintenance. If
issues persist, contact customer support for assistance.
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: — Reorient or relocate the receiving antenna. — Increase the separation between the equipment and receiver. — Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
Documents / Resources
 |
YUHANUS YHK10 Keypad Access Control [pdf] User Manual YHK10 Keypad Access Control, YHK10, Keypad Access Control, Access Control, Control |