YUHANUS RF Wireless Remote Control Switch Instruction Manual

YUHANUS-logo

YUHANUS RF Wireless Remote Control Switch

YUHANUS-RF-Wireless-Remote-Control-Switch-product-image

Technical Parameters

1. Operating voltage: 9V-72VDC/85V~265VAC
2. Static working current: ≤10mA
3. Operating temperature: -40°C~+80°C
4. Receive sensitivity: ≥-100dB
5. Operating frequency: 315MHZ, 433.92MHZ
6. Output current: ≤30A
7. Working mode: point movement, interlock, self-locking, and delay (5S / 10S / 15S / 20S)
8. Output mode: 9V-72VDC/85V~265VAC
9. Overall dimension: 66*45*30mm
10. Weight: 70g

Pattern Pairing Method

Clear Code
Press and hold the learning button of the controller for 5 seconds, the LED light flashes off and the code is cleared successfully. All previously paired remotes are cleared!

Pattern Pairing Method

  • Momentary Learning Method
    Press the learning button of the controller 1 time, the LED light will flash and light on, press the button of the remote control, the LED light will flash twice, the learning is successful.
  • Toggle Learning Method
    Press the learning button of the controller 2 times, the LED light flashes steadily, press the remote control button, the LED light flashes twice and the learning is successful.
  • Latched Learning Method
    Press the controller learning button 3 times, the LED light flashes always on, press one remote control button, the LED light flashes 2 times, press another remote control button, the LED light flashes twice, the learning is successful.

Delay Setting

  • 5S: Press the controller learning button 4 times, the LED light flashes and lights up, press the remote control button, the LED light lights up. Flash twice to learn successfully.
  • 10S: Press the controller learning button 5 times, the LED light flashes and lights up, press the remote control button, the LED light lights up. Flash twice to learn successfully.
  • 15S: Press the controller learning button 6 times, the LED light flashes and lights up, press the remote control button, the LED light lights up. Flash twice to learn successfully.
  • 20S: Press the controller learning button 7 times, the LED light flashes and lights up, press the remote control button, the LED light lights up. Flash twice to learn successfully.

The remote control can be equipped with low power, medium power, and high power.YUHANUS-RF-Wireless-Remote-Control-Switch-image-1

Wiring Method

  • DC9V-72V Wiring
    The wiring involves connecting the FireWire, zero line, and output as indicated in the diagram.
  • DC85V-265V Wiring
    Connect light bulbs and other electric motor appliances using the FireWire, zero line, and output connections as shown in the diagram.

YUHANUS-RF-Wireless-Remote-Control-Switch-image-2

Documents / Resources

PDF thumbnailRF Wireless Remote Control Switch
Instruction Manual · RF Wireless Remote Control Switch, Wireless Remote Control Switch, Remote Control Switch, Control Switch, Switch

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.