TinyTronics LM3915 LED Audio Ipele Atọka
Awọn akoonu Iṣakojọpọ
| Orukọ ọja | Opoiye | PCB indicator |
| PCB | 1 | |
| 1MΩ resistor | 2 | R1, R2 |
| 4.7KΩ resistor | 6 | R3, R4, R5, R6, R7, R8 |
| Teng Jie Cool White LED – 5mm Clear | 6 | D1, D2, D3, D4, D5, D6 |
| Small switch – 90 Degrees – Extra Strong | 2 | SW1, SW2 |
| Ceramic Capacitor – 10uF 25V | 2 | C1,C2 |
| NPN Transistor BC547 | 2 | Q1, Q2 |
| CR2450 Battery Holder for PCB – Flat | 1 | adan1 |
| Optional: Duracell CR2450 3V Lithium Battery | 1 |
Color code resitor
- 1MΩ
brown, black, black, yellow, brown
- 4.7KΩ
yellow, voilet, black, brown, brown
Other supplies that are not included
- Irin tita.
- Solder waya.
- Ige pliers.
- Yiyan: Ribbon to hang the Snowflake DIY kit from.
- Yiyan: Stand for the Snowflake DIY kit.
Awọn ilana
Solder the components at the positions listed in the table above. Although the order does not matter, it is convenient to place the components from top to bottom according to the table. Note that the LEDs should be placed at the front of the PCB and the rest of the components on the back side.
When soldering the BC547 NPN Transistor, be careful not to push it too far into the PCB, or the pins will bend out too far and possibly damage the transistor. If you find that the pins are tight enough to solder, that is enough.
Before inserting the battery, cut off the excess pins of all components to prevent accidental short-circuit.
The Snowflake DIY kit includes two switches. SW1 can be used to turn the LEDs on or off, and SW2 can be used to set whether the LEDs are flashing or be on continuously.
Sisọmu
Awọn iwe aṣẹ / Awọn orisun
 |
TinyTronics LM3915 LED Audio Ipele Atọka [pdf] Awọn ilana LM3915 LED Audio Level Indicator, LM3915, LED Audio Level Indicator, Audio Level Indicator, Level Indicator, Indicator |