RT5066R2 Wireless Audio Transmitter Receiver
User Manual
Technology Specification
General Specifications
| Mode： | RT5066R2 |
| Transmission frequency : | 2.4G private protocol |
| DSP: | 24bit/198Khz |
| Main frequency: | 160MHz |
| Flash: | 8Mb |
Power Management
| Enter specifications: | 5V 1A adapter |
| Over voltage protection: | When the input voltage exceeds 15V, protection will automatically start |
| Antenna Configuration |
|
| Antenna configuration: |
Antenna configuration |
| Button and light | |
| Power button: | Long press to turn on/off |
| Input/output Interface | |
| DC 2.0: | Power input interface |
| RCA: | 3.5 stereo input/output interface |
| Key Indicators | |
| Working Distance： | Accessible up to 100 meters, equivalent to 320 feet(NO obstacle) Accessible up to 30-50 meters, equivalent to 98-164 feet(Have obstacle) |
| Delay ： | less than 20 ms(NO obstacle) 200ms (Have obstacle) |
| Sampling Rate： | 24bit/192kHz |
| Working current voltage： | 20mA/5V |
| Frequency range： | 20~20KHZ |
| Distortion： | <0.1% |
| Signal-to-noise ratio： |
85DB |
IN the BOX
| Adapter*3: | IN:AC100~240V 50/60Hz OUT:DC 5V 1A |
| Power cable*3: | Comply with UL certification |
| Audio cable*3: | RCA male to 3.5mm male |
| Antenna*3: | 2DB gain |
| Manual*1: | 1pcs |
| RT5066R2 | Transmitter 1pcs Receiver 2pcs |
Working Environment
| Operating Temperature: | -20℃—60℃ |
| Storage temperature: | -30℃—75℃ |
Product Connection
| Transmitter: | TV/PC/Smartphone/Projector/Tablet/MP3 player |
| Receiver: | Active Speaker/Active Subwoofer |
Working Instructions
| Step for transmitter: | 1.power on RT5066 transmitter by charging cable. 2.Plug the RCA to 3.5mm jack cable . RCA to RT5066 Bluetooth transmitter and 3.5mm jack to TV/PC/Projector/MP3 Player 3.LED will be flashing |
| Step for Receiver: | 1.Power on two RT5066 receiver by charging cable. 2. Plug the RCA to 3.5mm jack cable . RCA to two RT5066 receiver and 3.5mm jack to Active Speaker/Active Subwoofer. 3. LED will be flashing.When you complete both receiver and transmitter,the LED will stay on without flash.That means they have paired successfully.You can enjoy now. |
| Note on usage: | * Normally,when both transmitter and receivers charged,they will pair automatically.LED of them will stays on blue * If transmitter do not pair,please press the button of the transmitter until LED off.and then press until on,they will pair automatically. * If receivers do not pair,please press the button of both transmitter and the falsifying receiver until LED off.and then press until on,they will pair automatically。 * If it still do not work,please open the back of transmitter . * Power on the transmitter use a toothpick or needles to reset the receiver ,press the receiver paring button to repair . * If you have any questions about this, please refer to the video on the product page. |
Documents / Resources
 |
YMOO RT5066R2 Wireless Audio Transmitter Receiver [pdf] User Manual RT5066R2 Wireless Audio Transmitter Receiver, RT5066R2, Wireless Audio Transmitter Receiver, Audio Transmitter Receiver, Transmitter Receiver, Receiver, Wireless Receiver, Receiver RT5066R2 |