yangchi Button Switch
Product Information
Product Name: Switch
Batch/Serial Number: Button Switch
Manufacturer & Eu Representative Info
Manufacturer:
Company Name: Guangzhou yangchi auto parts co. LTD
Address: CN-2 # 1003 min joke Chuang, mining key ji yuan, tai he zhen, baryon district, Guangzhou.
E-Mail: ouyan99@dingtalk.com
Telephone: 86-13421389711
EU Authorized Representative:
Company Name: CET PRODUCT SERVICE LTD
Address: Osterholzallee 144 , 71636 Ludwigsburg Germany
E-Mail: info.cetservice@gmail.com
Telephone: Tel: +4971416432236
Compliance Information
eVatmaster Consulting GmbH Bettinastr. 30 60325 Frankfurt am Main, Germany contact@evatmaster.com
OST_EU_20220224000026
We simply act as EC representative for cross-border sellers, and are not manufacturers/importers/distributors for the product, nor involved in the manufacture/import/sale of the product. Therefore, we are not responsible for any after-sales services related to the product. In case of any product quality or infringement issues, the manufacturer/importer/seller shall be solely held responsible.
NOTE: This product must comply with all applicable safety and regulatory requirements in the market where it is sold. Sellers must assess which requirements and regulations apply based on the actual product type, function, and destination market.
Safety & Warnings
Important Safety Information
Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.\r\n·
Warning: Keep the device and its cord out of reach of children under 3 years old.\r\n· Keep away from children unless supervised by an adult.\r\n·
Do not use this product for purposes other than its intended use.\r\n· Inspect the product before each use; do not use if damaged.\r\n· Follow installation and operation guidelines to avoid injury.\r\n.
Instructions For Use
How to Replace a Faulty Window Switch:
Step 1: Disconnect the negative battery terminal before working on the switch to prevent short circuit. Next, unclip the handles using a screw driver. Lift the faulty switch out of its harness.
Step 2: If you don’t want to take off the door casing or the door handle, simply slide a flat-head screwdriver under The switch bezel and pry it until it loosens to access the housing.
Step 3: Once the switch pops out of the bezel, disconnect it from the wire harness and detach it from the outlet. Remove the rockers before inserting a new switch into the harness holes.
Step 4: Assemble the rockers into the new switch and snap the device into the bezel.
Documents / Resources
 |
yangchi Button Switch [pdf] Instruction Manual Button Switch, Switch |