XTRA EDGE Camera
Download the App
The Xtra app is required when using the camera. Scan the QR code displayed on the camera screen with your mobile phone to download and install the app.
Introduction
Button Features
Shutter/Record Button Button
| Operation | Description |
| Press Once | Take a photo or start/stop recording |
| Press and Hold when
powered off |
Power on quickly and begin shooting |
Quick Switch Button Button
| Operation | Description |
| Press Once | Power on or off |
| Press and Hold | Switch between shooting modes |
- USB-C Port: Used for charging.
Operating the Touchscreen
The camera is equipped with dual touchscreens. After the camera is powered on, both touchscreens of the camera display the live view as well as the microSD card information, battery level, and shooting mode. Tap or swipe on a touchscreen to interact with the camera.
Inserting the MicroSD Card
The footage shot on the camera is stored on a microSD card. A UHS I Speed Grade 3 rating microSD card is required due to the fast read and write speeds necessary for high-resolution video data.
Charging
Connect a USB C charger (not included) to the USB C port using the Type-C to Type-C PD cable (included). It is recommended to use a USB-C charger that supports Power Delivery or PPS (Programmable Power Supply).
Specifications
| Model | XCAMC01 |
| Operating Temperature | -20 ℃ to 45 ℃ (-4° to 113° F) |
| Built-in Storage Capacity | The camera does not have built-in storage, but storage capacity can be expanded by inserting a
microSD card. |
| Wi-Fi | |
| Wi-Fi Protocol | 802.11 a/b/g/n/ac |
| Wi-Fi Operating Frequency | 2.4000-2.4835 GHz, 5.150-5.250 GHz, 5.725-5.850
GHz |
| Wi-Fi Transmission Power（EIRP） | 2.4 GHz: <15 dBm (FCC/CE/SRRC/MIC)
5.1 GHz: <16 dBm (FCC/CE/SRRC/MIC) 5.8 GHz: <14 dBm (FCC/CE/SRRC) |
| Bluetooth | |
| Bluetooth Protocol | BLE 5.0，BR/EDR |
| Bluetooth Operating Frequency | 2.4000-2.4835 GHz |
| Bluetooth Transmission Power
(EIRP) |
< 14 dBm |
| Battery | |
| Capacity | 1900 mAh |
| Type | LiPo 1S |
| Charging Temperature | 5 ℃ to 40 ℃ (41° to 104° F) |
| Voltage | 3.87 V |
| Max Charging Power | 23 W |
FCC Compliance Notice
Supplier’s Declaration of Conformity
- Product name: XTRA EDGE
- Model Number: XCAMC01
- Responsible Party: Xtra Technology LLC
- Responsible Party Address: 3422 Old Capitol Trail, Suite 700, Wilmington, DE 19808-6124, USA
- Website: www.xtra-us.com
We, Xtra Technology LLC, being the responsible party, declare that the above-mentioned model was tested to demonstrate compliance with all applicable FCC rules and regulations. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The end user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the head and body. These requirements set a SAR limit of 4 W/kg averaged over ten grams of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the limbs.
WARNING
- Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
- Even used batteries may cause severe injury or death.
- Call a local poison control center for treatment information.
- This product contains a non-replaceable ML414H IVOIE coin battery (nominal voltage: 3.1V).
- Do not force discharge, disassemble, heat above 600C or incinerate. Doing so may result in injury due to venting, leakage or explosion, resulting in chemical burns.
Frequently Asked Questions
Does the camera come with built-in storage?
No, the camera does not have built-in storage, but you can expand the storage capacity by inserting a microSD card.
Documents / Resources
 |
XTRA EDGE Camera [pdf] User Guide XCAMC01, 2BQH2-XCAMC01, 2BQH2XCAMC01, EDGE Camera, EDGE, Camera |