XIGMATEK ARGB and PWM Remote Control Box
Specifications
ARGB & PWM Control Box Power Consumption
- 5V: Total 40W maximum
- 12V: Total 36W maximum
Wireless Remote Control
ON/OFF
LED Display Speed
LED Display Mode
Auto Loop Mode
LED Display Brightness
Rainbow Display Mode
LED Mode (White/Red/Green/Blue)
Fan Speed (Low/Medium/High)
ARGB & PWM Control Box
- FG PWM (Red Socket)
- 4 Pin PWM Port
- Pin ARGB Port
- SATA Power Cable (To PSU)
- MB Sync ARGB Cable Connect to ARGB Motherboard if Available
- Reset/LED Cable onnect to PC Case 2 Pin Button to Switch ED Display Mode
Caution
- Please Do Not Over Power the ARGB & PWM Control Box, It Is Dangerous and Might Cause Damage!
- Please Check Your PSU 5V & 12V Power Output Specification, Make Sure PSU Single SATA Connector Can Support Sufficient Power Output to Avoid PSU Cable Overheat and Meltdown.
- Please Use at Least 450W PSU and 18AWG Thickness SATA Cable if Connect More Than 6 Fans.
- It Will Not Work with 4-Pin RGB or 12V RGB Fans or Light Strips.
FAQ
What is the purpose of the FG PWM socket?
The FG PWM socket is used to enable the fan speed feedback function.
What power supply should I use with this control box?
Use at least a 450W PSU and 18AWG thickness SATA cable if connecting more than 6 fans.
How can I synchronize the lighting with my motherboard?
Use the MB Sync ARGB Cable to connect to an ARGB motherboard if available.
Documents / Resources
 |
XIGMATEK ARGB and PWM Remote Control Box [pdf] User Guide ARGB and PWM Remote Control Box, PWM Remote Control Box, Remote Control Box, Control Box |