Wuhan Guide Sensmart Tech
3M BTC Bluetooth Remote Controller
Instructions

Wuhan Guide Sensmart Tech 3M BTC Bluetooth Remote Controller

Power button:

Long press the power button to start up the Bluetooth remote controller.
Remark: If the Bluetooth remote controller is not connected to the thermal imager within 3 minutes, it will automatically shut down.

Up button:

After the connection with a thermal imager, all functions of the “Up button” from the thermal imager can be operated.

Menu button:

After the connection with a thermal imager, all functions of the “Menu button” from the thermal imager can be operated.

Down button:

After the connection with a thermal imager, all functions of the “Down button” from the thermal imager can be operated.

Indicator:

Red: It keeps a constant red indicating for a certain while and goes off if the Bluetooth remote controller is on but not connected with a thermal imager.
Green: It keeps a constant green indicating for a certain while and goes off if the Bluetooth remote controller is on and connected with a thermal imager.
Red flicker: It flickers for a certain while and goes out if the battery capacity of the Bluetooth remote controller is low.

Installation Methods:

The Bluetooth remote controller is fixed by magic tape, the matte surface is attached to the fixed point while the hook surface is stuck to the back of the remote controller, and both the matte and the hook surfaces are affixed and fixed together.
Wuhan Guide Sensmart Tech Co., Ltd.
http://www.guideir.com

FCC WARNING: This equipment may generate or use radiofrequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.
  • The rating information is located at the bottom of the unit.

Documents / Resources

Wuhan Guide Sensmart Tech 3M BTC Bluetooth Remote Controller [pdf] Instructions
3M, 2AKU53M, Bluetooth Remote Controller, 3M BTC Bluetooth Remote Controller

Leave a comment

Your email address will not be published.