wopet logoFT50
Quick Start Guide

Panel Introduction

wopet FT50 Automatic Cat Feeders

Program setting

Our device uses a 24-hour clock system, for example, 16:00 is equivalent to 4:00 PM (see page 16 in the user manual for details).
Step 1 – Unlock
Power up OR long press wopet FT50 Automatic Cat Feeders - icon 2s if screen locked.wopet FT50 Automatic Cat Feeders - Fig

Step 2 – Set current time
Clock icon flashes, press wopet FT50 Automatic Cat Feeders - icon to start setting current time with wopet FT50 Automatic Cat Feeders - icon 1 then press wopet FT50 Automatic Cat Feeders - icon to save.wopet FT50 Automatic Cat Feeders - Fig 1

Step 4 – Return main interface
All setting done press wopet FT50 Automatic Cat Feeders - icon 3 back to main interface.wopet FT50 Automatic Cat Feeders - Fig 2

Step 3.1 – Set feeding time
Press wopet FT50 Automatic Cat Feeders - icon 2 then number 1 flashes, press wopet FT50 Automatic Cat Feeders - icon and wopet FT50 Automatic Cat Feeders - icon 1 to set the feeding time and press wopet FT50 Automatic Cat Feeders - icon to save.wopet FT50 Automatic Cat Feeders - Fig 3Step 3.2 – Set feeding portion
Press the wopet FT50 Automatic Cat Feeders - icon 1 to adjust the portion,then presswopet FT50 Automatic Cat Feeders - icon  to save.
Note:
max 8 portions for each meal, 1 portions = 4/3Tbsp(1/12cup, 20ml)wopet FT50 Automatic Cat Feeders - Fig 4Step 3.3 – Set other meals plan
Press wopet FT50 Automatic Cat Feeders - icon 2 move the next meal setting, repeat steps to set up feeding time and portion.wopet FT50 Automatic Cat Feeders - Fig 5

FAQs

How to set the current time

1. Upon turning on, press the settings button to enter current time setup. 2. The clock will flash, adjust the hours using the up and down keys, and save by pressing the settings button. 3. At this point, the minutes will flash, adjust the minutes using the up and down keys, and again save by pressing the settings button. 4. When the numbers for hours and minutes are no longer flashing, the current time setting is complete.

How to set the Feeding time

1. Please ensure to set the correct current time first. 2. Press the down button to enter the setup for the first meal. the number “1

Food did not dispense at the set time

1, Ensure the food's diameter is less than 12mm, only suitable for dry food. 2. Check if the turntable is jammed, if so please clean it first (see pages 10-11 in the user manual for details). 3. Check if the food container still has food, please replenish in time if it’s running low. 4. If it is battery-powered, please ensure there's sufficient battery power. We recommend using the plug and batteries at the same time. 5. For first-time use, please manually feed four times to ensure the food fills the slot. Press the manual feeding button on the machine to feed.

The voice broadcast volume is too low

When recording, try to be as close to the machine as possible and speak a little louder.

How much is each portion?

I portions = 12g = 20ml =1/12cup = 4tsp = 4/3Tbsp

The buttons are not responding, there's no sound.

Make sure the device is not locked. if it is, please unlock it first.

How to cancel the feeding plan for the first meal ?

Please set the number of feeding portions for the first meal to 0

T

hank you for choosing WOPET pet feeder.
Please read the quick guide before using, If you have any problems when using our product, kindly send email with order number to our mailbox: support@wopet.com for help, we’ll response within 24 hours.

wopet logowopet FT50 Automatic Cat Feeders - QR Codehttps://qr06.cn/D2Qa8T 
Scan the QR code to set up the feeder

>Documents / Resources
wopet FT50 Automatic Cat Feeders [pdf] User Guide
FT50 Automatic Cat Feeders, FT50, Automatic Cat Feeders, Cat Feeders, Feeders

References

Leave a comment

Your email address will not be published. Required fields are marked *