WitMotion BWT901CL Bluetooth Accelerometer
Overview
The BWT901CL BLE 2.0 / BWT901BLECL Ble 5.0 9-axis accelerometer, gyroscope, and horizontal tilt angle sensor module is designed for reliable operation when installed and used according to the provided instructions.
Specifications
| Product name | BWT901CL Ble 2.0 BWT901BLECL Ble 5.0 9 Axis 9-axis Accelerometer Gyroscope Horizontal Tilt Angle Sensor Module |
| Model | BWT901CL Ble 2.0 / BWT901BLECL Ble 5.0 |
| Batch/Serial number | 1005008071954798 |
- Compliance: CE (Low Voltage Directive 2014/35/EU; EMC Directive 2014/30/EU)
- RoHS: Complies with Directive 2011/65/EU and amendment (EU) 2015/863
Setup & Use
- Read all instructions before use.
- Before integration, ensure the operational environment matches the product’s technical parameters and verify compatibility with existing systems.
- Inspect the product before each use; do not use if damaged.
- Install by following established procedures for component placement and connection, handling the product properly to maintain integrity.
- During operation, keep conditions within the prescribed ranges and monitor performance indicators continuously.
- Maintain the module with routine maintenance and periodic inspections; store it in a dry place and keep it away from children.
- Warning: Keep the device and its cord out of reach of children under 3 years old.
- Keep away from children unless supervised by an adult.
- Do not use this product for purposes other than its intended use.
- Inspect the product before each use; do not use if damaged.
- Follow installation and operation guidelines to avoid injury.
- Do not expose to water or moisture.
Instructions
General Guidance
This product is designed and manufactured in accordance with industry-standard specifications to ensure optimal performance and reliability. Users are expected to adhere to the following guidelines to maximize component functionality and service life.
Pre-Installation Considerations
Prior to integration, ensure that the operational environment aligns with specified technical parameters. It is recommended to verify compatibility with existing systems to facilitate seamless implementation.
Installation Process
Follow established procedures for component placement and connection. Proper handling is essential to maintain integrity and prevent potential performance degradation.
Operational Notes
During use, maintain conditions within the prescribed ranges. Continuous monitoring of performance indicators is advised to sustain operational excellence.
Maintenance & Care
Implement routine maintenance protocols to uphold product standards. Periodic inspections are encouraged to ensure ongoing compliance with quality expectations. Store it in a dry place. Keep away from children.
Disclaimer
The manufacturer assumes no liability for outcomes resulting from non-compliance with these instructions, improper use, or unauthorized modifications. Specifications are subject to change without prior notice.
For further details, consult the official documentation or contact our support team.
Troubleshooting
- Device damaged on arrival or during use: Inspect the product before each use and do not use it if damaged.
- Possible misuse or unsafe operation: Ensure you are using the product only for its intended use and follow installation and operation guidelines to avoid injury.
- Environmental issues: Do not expose the product to water or moisture; keep operating conditions within the prescribed ranges.
- Performance concerns: Maintain recommended operating conditions and perform periodic inspections to support ongoing compliance with quality expectations.
Documents / Resources
 | BWT901CL Bluetooth Accelerometer |
References
- User Manualmanual.tools